enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Surge protector - Wikipedia

   en.wikipedia.org/wiki/Surge_protector

   Surge Protection Device (SPD) for installation in a low-voltage distribution board. A surge protector (or spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD), transient voltage suppressor (TVS) or transient voltage surge suppressor (TVSS)) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes ...

3. IEC 61000-4-5 - Wikipedia

   en.wikipedia.org/wiki/IEC_61000-4-5

   It necessitates the test of surge immunity in electrical or electronic equipment. IEC 61000-4-5 defines test set-up, procedures, and classification levels. In particular, it standardizes the required surge voltage and current waveforms for laboratory testing, with the "1.2/50-8/20 μs" impulse being the most frequently used surge waveform.

4. Transient-voltage-suppression diode - Wikipedia

   en.wikipedia.org/wiki/Transient-voltage...

   A transient-voltage-suppression diode can respond to over-voltages faster than other common over-voltage protection components such as varistors or gas discharge tubes. The actual clamping occurs in roughly one picosecond, but in a practical circuit the inductance of the wires leading to the device imposes a higher limit. This makes transient ...

5. Varistor - Wikipedia

   en.wikipedia.org/wiki/Varistor

   Metal-oxide varistor manufactured by Siemens & Halske AG. Modern varistor schematic symbol, which is the same as a thermistor symbol [1]. A varistor (a.k.a. voltage-dependent resistor (VDR)) is a surge protecting electronic component with an electrical resistance that varies with the applied voltage. [2]

6. Inrush current - Wikipedia

   en.wikipedia.org/wiki/Inrush_current

   Inrush current, input surge current, or switch-on surge is the maximal instantaneous input current drawn by an electrical device when first turned on. Alternating-current electric motors and transformers may draw several times their normal full-load current when first energized, for a few cycles of the input waveform.

7. Power system protection - Wikipedia

   en.wikipedia.org/wiki/Power_system_protection

   Power system protection is a branch of electrical power engineering that deals with the protection of electrical power systems from faults [citation needed] through the disconnection of faulted parts from the rest of the electrical network. The objective of a protection scheme is to keep the power system stable by isolating only the components ...