Search results
Results from the WOW.Com Content Network
Frequent fluid changes, especially when used for towing, are the single best method to prevent shudder. A shudder occurs because the torque converter never fully enters "lock-up" and ends up bouncing in and out of lock-up to slip. This causes the engine to flare up and then down again as the clutch cannot hold back the power of the engine.
A torque converter is a device, usually implemented as a type of fluid coupling, that transfers rotating power from a prime mover, like an internal combustion engine, to a rotating driven load. In a vehicle with an automatic transmission, the torque
The hydrodynamic torque converter was largely taken over from the previous 7G-Tronic transmission. It has a torque converter lock-up clutch and a twin-turbine harmonic damper with centrifugal pendulum absorber technology. [8] The torque converter lock-up can operate in all 9 forward gears.
By historical context of comparison, the '50 Packard Ultramatic which was a torque converter applied two speed lock-up design with high and low range for four forward speeds and the '50 Studebaker/Detroit Gear featured a lock-up torque converter with three forward speeds. The lock-up feature of Packard's Ultramatic and Studebaker's DG 250 is ...
Compared to the early cast-iron transmissions, many and various internal improvements were featured, and it used a 10.75 in (27.3 cm) or 11.75 in (29.8 cm) torque converter. The heavier-duty A727 Torqueflites became — and remain — wildly popular for drag racing , off roading , and monster truck applications because of their controllability ...
The Type-H fluid specification provided improved friction characteristics in lock-up torque converters (reducing shudder during application and release). With this new specification, Ford introduced the aluminum beaker oxidation test (ABOT) to replace the older Merc-O-Matic oxidation test.
The 5G-Tronic (model W5A 330 and W5A 580 · type 722.6) is an electronically shifted 5-speed overdrive automatic transmission with torque converter lock-up (typically in gears 3, 4 and 5) and 2-speed for reverse.
Once fully locked, the torque converter no longer applies torque multiplication and will spin at the same speed as the engine. This provides a major increase in fuel economy. Modern designs provide partial lockup in lower gears to improve fuel economy further, but this can increase wear on the clutch components.