enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Casing (borehole) - Wikipedia

   en.wikipedia.org/wiki/Casing_(borehole)

   Casing is a large diameter pipe that is assembled and inserted into a recently drilled section of a borehole. Similar to the bones of a spine protecting the spinal cord, casing is set inside the drilled borehole to protect and support the wellstream. The lower portion (and sometimes the entirety) is typically held in place with cement. [1]

3. Casing string - Wikipedia

   en.wikipedia.org/wiki/Casing_string

   A typical piece of casing might be described as 9-5/8" 53.5# P-110 LT&C Rg 3: specifying OD, weight per foot (53.5 lbm/ft thus 0.545-inch wall thickness and 8.535-inch inside diameter), steel strength (110,000 psi yield strength), end finish ("Long Threaded and Coupled"), and approximate length ("Range 3" usually runs between 40 and 42 feet).

4. Production tubing - Wikipedia

   en.wikipedia.org/wiki/Production_tubing

   Production casing is the final casing string set in a well and usually reaches from the surface to Target Depth (TD). The type of casing used depends upon the different conditions in the well. Commonly, production casing sizes range from 4 + 1 ⁄ 2 in (110 mm) to as large as 9 + 5 ⁄ 8 in (240 mm). It is the last string cemented in a well ...

5. Christmas tree (oil well) - Wikipedia

   en.wikipedia.org/wiki/Christmas_tree_(oil_well)

   It consisted of a T-valve, with a 6-inch (150 mm) and 8-inch (200 mm) valve on the vertical pipe, and a 6-inch valve on the horizontal pipe. The vertical valve was closed first, and then the valve to the horizontal pipe. [1] [2] Christmas trees are used on both surface and subsea wells.

6. Completion (oil and gas wells) - Wikipedia

   en.wikipedia.org/wiki/Completion_(oil_and_gas_wells)

   Completion (oil and gas wells) Well completion is the process of making a well ready for production (or injection) after drilling operations. This principally involves preparing the bottom of the hole to the required specifications, running in the production tubing and its associated down hole tools as well as perforating and stimulating as ...

7. Casing hanger - Wikipedia

   en.wikipedia.org/wiki/Casing_hanger

   The casing head is prepared with a bowl into which the slips sit and chuck the casing in place. Most casing heads allow for the pressure readings to be taken on the annulus and provide the means to pump out or into if necessary. The top of the casing string and annulus is usually sealed. The most common size of casing hanger is 13 + 3 ⁄ 8 in ...

8. Wellhead - Wikipedia

   en.wikipedia.org/wiki/Wellhead

   A wellhead is the component at the surface of an oil or gas well that provides the structural and pressure-containing interface for the drilling and production equipment. Wellhead gas storage, Etzel Germany. Oil well Christmas tree. The primary purpose of a wellhead is to provide the suspension point and pressure seals for the casing strings ...

9. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters. PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube (designated by actual size, with lower ...