Search results
Results from the WOW.Com Content Network
Ping time is an average time measured in milliseconds (ms). [ citation needed ] The lower one's ping is, the lower the latency is and the less lag the player will experience. High ping and low ping are commonly used terms in online gaming, where high ping refers to a ping that causes a severe amount of lag; while any level of ping may cause lag ...
Ping measures the round-trip time for messages sent from the originating host to a destination computer that are echoed back to the source. The name comes from active sonar terminology that sends a pulse of sound and listens for the echo to detect objects under water. [1] Ping operates by means of Internet Control Message Protocol (ICMP) packets.
If a host tries to send data through a router (R1) and R1 sends the data on another router (R2) and a direct path from the host to R2 is available (that is, the host and R2 are on the same subnetwork), then R1 will send a redirect message to inform the host that the best route for the destination is via R2. The host should then change its route ...
A specified period of time that will be allowed to elapse in a system before a specified event is to take place, unless another specified event occurs first; in either case, the period is terminated when either event takes place. Note: A timeout condition can be canceled by the receipt of an appropriate time-out cancellation signal.
RTT is a measure of the amount of time taken for an entire message to be sent to a destination and for a reply to be sent back to the sender. The time to send the message to the destination in its entirety is known as the network latency, and thus RTT is twice the latency in the network plus a processing delay at the destination. The other ...
MTR also has a User Datagram Protocol (UDP) mode (invoked with "-u" on the command line or pressing the "u" key in the curses interface) that sends UDP packets, with the time to live (TTL) field in the IP header increasing by one for each probe sent, toward the destination host. When the UDP mode is used, MTR relies on ICMP port unreachable ...
Packet loss occurs when one or more packets of data travelling across a computer network fail to reach their destination. Packet loss is either caused by errors in data transmission, typically across wireless networks, [1] [2] or network congestion. [3]: 36 Packet loss is measured as a percentage of packets lost with respect to packets sent.
The command provides details of the path between two hosts and ping-like statistics for each node in the path based on samples taken over a time period, depending on how many nodes are between the start and end host. The advantages of PathPing over ping and traceroute are that each node is pinged as the result of a single command, and that the ...