Search results
Results from the WOW.Com Content Network
SAPI plates meant for body armor come in front and back plates which are identical, and smaller side plates. The front and back plates come in five sizes. Their dimensions are the following: [1] [13] Front and back SAPI plates: Extra Small - 1.27 kg (2.8 lb) | 184 x 292 mm (7¼ x 11½ in) Small - 1.59 kg (3.5 lb) | 222 x 298 mm (8¾ x 11¾ in)
A pair of Small Arms Protective Insert plates, circa April 2006. These were issued to US Army units, before being replaced by the ESAPI. A ballistic plate, also known as an armour plate, is a protective armoured plate inserted into a carrier or bulletproof vest, that can be used stand-alone, or in conjunction with other armour. "Hard armour ...
The Improved Modular Tactical Vest (IMTV) and Improved Scalable Plate Carrier (ISPC) are the new models. "The IMTV will be the main body armor system for Marines, the Corps plans to order about 70,000 of the improved plate carriers, far more than the estimated 10,000 to 14,000 plate carriers in use today". [30]
Extra plate that covers the front of the shoulder and the armpit, worn over top of a pauldron. Rerebrace or brassart or upper cannon (of vambrace) Plate that covers the section of upper arm from elbow to area covered by shoulder armour. Besagew: Circular plate that covers the armpit, typically worn with spaulders. See also rondel.
Two versions of the vest are available, known as the "land" and "maritime" versions. The vest consists of front and rear panels with pockets for BALCS or SPEAR-cut soft armor panels and standard-issue SAPI (Small Arms Protective Insert) plates. This gives the wearer up to NIJ Level IV protection on the front and back and Level IIIA protection ...
Personnel Armor System for Ground Troops (PASGT, pronounced / ˈ p æ z ɡ ə t / PAZ-gət) is a combat helmet and ballistic vest that was used by the United States military from the early 1980s until the early or mid-2000s, when the helmet and vest were succeeded by the Lightweight Helmet (LWH), Modular Integrated Communications Helmet (MICH), and Interceptor body armor (IBA) respectively.
Most of them were made of RHA plates , or thick reinforced rubbers , and worked in the same way as did WW2-era ones. Some WWII armoured vehicles used nets of wooden logs at a certain distance from the hull as makeshift spaced armour to protect the vehicle from magnetic mines , thrown shaped charges and grenades, and occasionally suicidal ...
6B12-2 - Produced by NII Stali. 9.5 mm titanium plate or 5.6 mm steel plate on the front. [2] 6B12-3 - Produced by ZAO Artess. Was withdrawn from service due to corruption scandal. [1] 6B12-4 - Produced by NPP KIASS. Steel 6.5 mm plate on the front. [2] 6B12M - Produced by Kirasa. With armor elements made of “44C” steel of increased ...