Search results
Results from the WOW.Com Content Network
multi position switch, in 83a out position 1 83b out position 2 Relay; 85 relay coil - Important if relay coil has flyback diode in parallel 86 relay coil + Important if relay coil has diode in parallel Relay contacts 87 common contact 30/51 87a normally closed contact 87b normally open contact 88 common contact 2 30/51 (relay) 88a
The above realizes the function: Door motor = Key switch 1 AND Key switch 2 This circuit shows two key switches that security guards might use to activate an electric motor on a bank vault door. When the normally open contacts of both switches close, electricity is able to flow to the motor which opens the door.
A Piping and Instrumentation Diagram (P&ID or PID) is a detailed diagram in the process industry which shows process equipment together with the instrumentation and control devices.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
These switches appear externally similar to single pole, single throw (SPST) switches, but have extra connections which allow a circuit to be controlled from multiple locations. Toggling the switch disconnects one "traveler" terminal and connects the other. Electrically, a typical "3-way" switch is a single pole, double throw (SPDT) switch. By ...
Template:Location map; Template:Location map many; Template:Location map+; Template:Location map~ Maps can be searched for at Commons:Category:Location maps by country. Icons can be found at Commons:Category:Map icons. These tricks are sometimes useful: Comment: <!--comment-->
Upgrade to a faster, more secure version of a supported browser. It's free and it only takes a few moments:
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.