Search results
Results from the WOW.Com Content Network
A patch antenna is a narrowband, wide-beam antenna fabricated by etching the antenna element pattern in metal trace bonded to an insulating dielectric substrate, such as a printed circuit board, with a continuous metal layer bonded to the opposite side of the substrate which forms a ground plane. Common microstrip antenna shapes are square ...
An antenna like effect is achieved by periodic swing of electrons from its capacitive element to the ground plane which behaves like an inductor. The authors further argued that the operation of a dielectric antenna resembles the antenna conceived by Marconi, the only difference is that inductive element is replaced by the dielectric material. [5]
Stubs can be constructed with any type of transmission line: parallel conductor line (where they are called Lecher lines), coaxial cable, stripline, waveguide, and dielectric waveguide. Stub circuits can be designed using a Smith chart, a graphical tool which can determine what length line to use to obtain a desired reactance.
Cross-section of microstrip geometry. Conductor (A) is separated from ground plane (D) by dielectric substrate (C). Upper dielectric (B) is typically air. Microstrip is a type of electrical transmission line which can be fabricated with any technology where a conductor is separated from a ground plane by a dielectric layer known
The ESR is a derived quantity representing the loss due to both the dielectric's conduction electrons and the bound dipole relaxation phenomena mentioned above. In a dielectric, one of the conduction electrons or the dipole relaxation typically dominates loss in a particular dielectric and manufacturing method. For the case of the conduction ...
The dielectric losses depend only on the substrate and not on the geometry: unlike the conduction losses, is not influenced by the substrate thickness. It transpires that the only way to reduce α D {\displaystyle \alpha _{D}} consists in choosing a template with better dielectric properties: the lower the loss tangent tan δ {\displaystyle ...
A patch antenna is a type of antenna with a low profile, usually consisting of a printed circuit board. It consists of a planar rectangular or circular sheet or "patch" of metal, mounted over a larger sheet of metal called a ground plane. It is the original type of microstrip antenna described by Howell in 1972. [1]
A Vivaldi antenna or Vivaldi aerial [1] or tapered slot antenna [2] is a co-planar broadband-antenna, which can be made from a solid piece of sheet metal, a printed circuit board, or from a dielectric plate metalized on one or both sides. Patterned Vivaldi antenna, made from double-sided printed circuit board material