Search results
Results from the WOW.Com Content Network
SENT uses pulse-width modulation to encode four bits (one nibble) per symbol. The basic unit of time in SENT is called a tick, where a tick can be between 3 - 90 μs, at the sender's option. Each message is preceded by a calibration pulse with a period of 56 ticks for framing and calibration of tick length.
Pulse width is an important measure in radar systems. Radars transmit pulses of radio frequency energy out of an antenna and then listen for their reflection off of target objects. The amount of energy that is returned to the radar receiver is a function of the peak energy of the pulse, the pulse width, and the pulse repetition frequency.
The average output voltage is directly proportional to the ON time of chopper. The ratio of ON time to total time is defined as duty cycle. It can be varied between 0 and 1 or between 0 and 100%. Pulse-width modulation (PWM), or pulse-duration modulation (PDM), is a technique used to encode a message into a pulsing signal.
Pulse-width modulation (PWM), also known as pulse-duration modulation (PDM) or pulse-length modulation (PLM), [1] is any method of representing a signal as a rectangular wave with a varying duty cycle (and for some methods also a varying period). PWM is useful for controlling the average power or amplitude delivered by an electrical signal.
In a digitally modulated signal or a line code, symbol rate, modulation rate or baud rate is the number of symbol changes, waveform changes, or signaling events across the transmission medium per unit of time. The symbol rate is measured in baud (Bd) or symbols per second. In the case of a line code, the symbol rate is the pulse rate in pulses ...
The unit interval is the minimum time interval between condition changes of a data transmission signal, also known as the pulse time or symbol duration time.A unit interval (UI) is the time taken in a data stream by each subsequent pulse (or symbol).
This msp430-elf-gcc compiler is supported by TI's Code Composer Studio version 6.0 and higher. There is a very early llvm-msp430 project, which may eventually provide better support for MSP430 in LLVM. Other commercial development tool sets, which include editor, compiler, linker, assembler, debugger and in some cases code wizards, are available.
The word pulse in the term pulse-code modulation refers to the pulses to be found in the transmission line. This perhaps is a natural consequence of this technique having evolved alongside two analog methods, pulse-width modulation and pulse-position modulation , in which the information to be encoded is represented by discrete signal pulses of ...