Search results
Results from the WOW.Com Content Network
NATCP [13] – Network-Assisted TCP uses out-of-band explicit feedback indicating minimum RTT of the network and capacity of the cellular access link. The variable-structure congestion control protocol (VCP) uses two ECN bits to explicitly feedback the network state of congestion. It includes an end host side algorithm as well. [citation needed]
The ideal buffer is sized so it can handle a sudden burst of communication and match the speed of that burst to the speed of the slower network. Ideally, the shock-absorbing situation is characterized by a temporary delay for packets in the buffer during the transmission burst, after which the delay rapidly disappears and the network reaches a ...
ITU-T Y.1564 is designed to serve as a network service level agreement (SLA) validation tool, ensuring that a service meets its guaranteed performance settings in a controlled test time, to ensure that all services carried by the network meet their SLA objectives at their maximum committed rate, and to perform medium- and long-term service testing, confirming that network elements can properly ...
A solution recommended by Nagle, that prevents the algorithm sending premature packets, is by buffering up application writes then flushing the buffer: [1] The user-level solution is to avoid write–write–read sequences on sockets. Write–read–write–read is fine. Write–write–write is fine. But write–write–read is a killer.
Bufferbloat is the undesirable latency that comes from a router or other network equipment buffering too many data packets.Bufferbloat can also cause packet delay variation (also known as jitter), as well as reduce the overall network throughput.
In routers and switches, active queue management (AQM) is the policy of dropping packets inside a buffer associated with a network interface controller (NIC) before that buffer becomes full, often with the goal of reducing network congestion or improving end-to-end latency.
The extension was subsequently standardized by the Priority-based Flow Control (PFC) project authorized on March 27, 2008, as IEEE 802.1Qbb. [7] Draft 2.3 was proposed on June 7, 2010. Claudio DeSanti of Cisco was editor. [8] The effort was part of the data center bridging task group, which developed Fibre Channel over Ethernet. [9]
These mechanisms control the rate of data entering the network, keeping the data flow below a rate that would trigger collapse. They also yield an approximately max-min fair allocation between flows. Acknowledgments for data sent, or the lack of acknowledgments, are used by senders to infer network conditions between the TCP sender and receiver.