Search results
Results from the WOW.Com Content Network
In Australia, Visual Navigation Charts (VNCs) and Visual Terminal Charts (VTCs) usually indicate MEF information by use of bold elevation figures for each grid. Pilots are also required to ensure their planned route does not contravene the minimum flying altitude regulations contained in CAR 167. This restriction is normally 1000FT above ...
In aviation, instrument flight rules (IFR) is one of two sets of regulations governing all aspects of civil aviation aircraft operations; the other is visual flight rules (VFR). The U.S. Federal Aviation Administration 's (FAA) Instrument Flying Handbook defines IFR as: "Rules and regulations established by the FAA to govern flight under ...
The rule affected only those aircraft operating under IFR when in level flight above 3,000 ft above mean sea level, or above the appropriate transition altitude, whichever is the higher, and when below FL195 (19,500 ft above the 1013.2 hPa datum in the UK, or with the altimeter set according to the system published by the competent authority in ...
En-route charts are divided into high and low versions, with information on airways and navaids for high- and low-altitude flight, respectively. The division between low altitude and high altitude is usually defined as the altitude that marks transition to flight levels (in the United States , this is taken to be 18,000 feet MSL by convention).
The cockpit of a Slingsby T-67 Firefly two-seat light airplane.The flight instruments are visible on the left of the instrument panel. Flight instruments are the instruments in the cockpit of an aircraft that provide the pilot with data about the flight situation of that aircraft, such as altitude, airspeed, vertical speed, heading and much more other crucial information in flight.
An approach plate for the ILS or LOC approach to runway 14L at Cologne Bonn Airport, Germany.. Approach plates (or, more formally, instrument approach procedure charts) are the printed or digital charts of instrument approach procedures that pilots use to fly instrument approaches during instrument flight rules (IFR) operations.
An aeronautical chart is a map designed to assist in the navigation of aircraft, much as nautical charts do for watercraft, or a roadmap does for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful ...
The initial altitude is sometimes stated on the charts. If not, it will be given by the air traffic controller. The departure frequency is given to the pilot when ATC hands the aircraft over to the next sector. A typical IFR clearance would be: OOABC, cleared to Ostend via the DENUT 7C departure, climb flight level six zero, squawk four six ...