Search results
Results from the WOW.Com Content Network
In computer networking, source routing, also called path addressing, allows a sender of a data packet to partially or completely specify the route the packet takes through the network. [1] In contrast, in conventional routing , routers in the network determine the path incrementally based on the packet's destination.
IPv6-Route Routing Header for IPv6: RFC 8200: 0x2C 44 IPv6-Frag Fragment Header for IPv6: RFC 8200: 0x2D 45 IDRP Inter-Domain Routing Protocol: 0x2E 46 RSVP Resource Reservation Protocol: RFC 2205: 0x2F 47 GRE Generic Routing Encapsulation: RFC 2784, RFC 2890: 0x30 48 DSR Dynamic Source Routing Protocol RFC 4728: 0x31 49 BNA Burroughs Network ...
On a network with a single edge router, it is possible to implement source-specific routing by manual manipulation of routing tables. [6] With multiple routers, explicit support for source-specific routing is required in the routing protocol. As of early 2016, there are two routing protocols that implement support for source-specific routing:
Routing protocols, according to the OSI routing framework, are layer management protocols for the network layer, regardless of their transport mechanism: IS-IS runs on the data link layer (Layer 2) Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link ...
Loose Source Routing is an IP option which can be used for address translation. LSR is also used to implement mobility in IP networks. [3] Loose source routing uses a source routing option in IP to record the set of routers a packet must visit. The destination of the packet is replaced with the next router the packet must visit.
Networks are separated from each other by specialized hosts, called gateways or routers with specialized software support optimized for routing. IP forwarding algorithms in most routing software determine a route through a shortest path algorithm. In routers, packets arriving at an interface are examined for source and destination addressing ...
In practice, only the IP Precedence part of the field was ever used outside US DoD networks: the higher the value of the IP Precedence field, the higher the priority of the IP packet. Some US DoD networks did use the delay bit for route selection between oceanic cable paths and Satellite Communication (SATCOM) paths when both paths existed.
Classless Inter-Domain Routing (CIDR / ˈ s aɪ d ər, ˈ s ɪ-/) is a method for allocating IP addresses for IP routing. The Internet Engineering Task Force introduced CIDR in 1993 to replace the previous classful network addressing architecture on the Internet .