Ads
related to: underfloor heating not reaching temperature change due to wet weatherheatingandairtoday.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Weather compensation is a technique for adjusting heating systems to reflect the outside weather, using weather compensation controls. [ 1 ] If the outside temperature drops, it will increase the temperature of the heating medium (typically, water or air) in the heating system.
There is a likelihood that underfloor heating may add to offgassing and sick building syndrome in an environment, particularly when the carpet is used as flooring. [citation needed] Electric underfloor heating systems cause low frequency magnetic fields (in the 50–60 Hz range), old 1-wire systems much more so than modern 2-wire systems.
The ground floor with a slab on grade has less temperature rise compared to middle and top floors, and an increase of the supply air temperature causes a decrease in the temperature rise. The temperature rise is not significantly affected by the perimeter zone orientation, the internal heat gain and the window-to-wall ratio. [16]
The wet-bulb temperature is the lowest temperature that may be achieved by evaporative cooling of a water-wetted, ventilated surface.. By contrast, the dew point is the temperature to which the ambient air must be cooled to reach 100% relative humidity assuming there is no further evaporation into the air; it is the temperature where condensation (dew) and clouds would form.
The building balance point temperature is the outdoor air temperature when the heat gains of the building are equal to the heat losses. [1] Internal heat sources due to electric lighting, mechanical equipment, body heat, and solar radiation may offset the need for additional heating although the outdoor temperature may be below the thermostat set-point temperature.
A ground source heat pump is used in winter to extract the warmth from the Thermal Bank to provide space heating via underfloor heating. A high Coefficient of performance is obtained because the heat pump starts with a warm temperature of 25 °C (77 °F) from the thermal store, instead of a cold temperature of 10 °C (50 °F) from the ground. [17]
The lower temperatures and large surface area of underfloor heating systems make them ideal heat emitters for air source heat pumps, evenly and effectively radiating the heat energy from the system into rooms within a home. The maximum temperature of the heating surface can vary from 29–35 °C (84–95 °F) depending on the room type.
The wet-bulb globe temperature (WBGT) combines the effects of radiation (typically sunlight), humidity, temperature and wind speed on the perception of temperature. It is not often used, since its measurement requires the use of a globe thermometer exposed to the sun, which is not included in standard meteorological equipment used in official ...
Ads
related to: underfloor heating not reaching temperature change due to wet weatherheatingandairtoday.com has been visited by 10K+ users in the past month