Search results
Results from the WOW.Com Content Network
Run-of-the-river, or ROR, hydroelectricity is considered ideal for streams or rivers that can sustain a minimum flow or those regulated by a lake or reservoir upstream. [ 1 ] [ 2 ] A small dam is usually built to create a headpond ensuring that there is enough water entering the penstock pipes that lead to the turbines , which are at a lower ...
Cross-flow turbine: Also known as Banki-Mitchell or Ossberger turbines, these devices are used for a large range of hydraulic heads (from 2 to 100 meters) and flow rates (from 0.03 to 20 m 3 /s), but are more efficient for low heads and low power outputs. They are considered "impulse" turbines, since they get energy from water by reducing its ...
The average flow rate at the mouth of the Amazon is sufficient to fill more than 83 such pools each second. The estimated global total for all rivers is 1.2 × 10 6 m 3 /s (43 million cu ft/s), [ 1 ] of which the Amazon would be approximately 18%.
For example, a low-head hydro power plant with hydrostatic head of few meters to few tens of meters can be classified either as an SHP or an LHP. [30] The other distinction between SHP and LHP is the degree of the water flow regulation: a typical SHP primarily uses the natural water discharge with very little regulation in comparison to an LHP.
A hydropower resource can be evaluated by its available power. Power is a function of the hydraulic head and volumetric flow rate. The head is the energy per unit weight (or unit mass) of water. [5] The static head is proportional to the difference in height through which the water falls. Dynamic head is related to the velocity of moving water.
This list of waterfalls by flow rate includes all waterfalls which are known to have an average flow rate or discharge of at least 150 cubic metres per second (5,300 cu ft/s). The waterfalls in this list are those for which there is verifiable information, and the list should not be assumed to be a complete list of waterfalls which would ...
It takes in water at one "hydraulic head" (pressure) and flow rate, and outputs water at a higher hydraulic head and lower flow rate. The device uses the water hammer effect to develop pressure that allows a portion of the input water that powers the pump to be lifted to a point higher than where the water originally started.
In most contexts a mention of rate of fluid flow is likely to refer to the volumetric rate. In hydrometry, the volumetric flow rate is known as discharge. Volumetric flow rate should not be confused with volumetric flux, as defined by Darcy's law and represented by the symbol q, with units of m 3 /(m 2 ·s), that is, m·s −1. The integration ...