Search results
Results from the WOW.Com Content Network
Tangent keys are used in high-torque heavy-duty applications. What would have been the side of each keyway forms heels against which the key sits, and transfers force compressively. This latter point means that for reversible motion of the shaft, another key along a tangent outwards in the opposing direction is needed.
Shaft angle. A shaft angle is the angle between the axes of two non-parallel gear shafts. In a pair of crossed helical gears, the shaft angle lies between the oppositely rotating portions of two shafts. This applies also in the case of worm gearing. In bevel gears, the shaft angle is the sum of the two
ISO 2491:1974 Thin parallel keys and their corresponding keyways (Dimensions in millimetres) [Withdrawn without replacement] ISO 2492:1974 Thin taper keys with or without gib head and their corresponding keyways (Dimensions in millimetres) [Withdrawn without replacement] ISO 2493 Paper and board — Determination of bending resistance
Bright Key Steel; Dimensions, Permissible Variations, Weights: Active: DIN 6885-1: Drive Type Fastenings without Taper Action – Part 1: Parallel Keys, Keyways, Deep Pattern: Active: DIN 6885-2: Drive Type Fastenings without Taper Action – Part 2: Parallel Keys, Keyways, Deep Pattern for Machine Tools, Dimensions and Application: Active: DIN ...
Keyway may refer to: A part of a keyed joint used to connect a rotating machine element to a shaft; see key (engineering) A keyhole , a hole or aperture (as in a door or lock) for receiving a key; see lock and key
For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear. Adjacent images in the section below show a transmission input shaft with male splines and a clutch plate with mating female splines in the center hub, where the smooth tip of the axle would be supported in a pilot bearing in ...
ISO 3912:1977 Woodruff keys and keyways [Withdrawn without replacement] ISO 3913:1977 Shipbuilding — Welded steel bollards; ISO 3914 Textile machinery and accessories — Cylindrical tubes ISO 3914-1:1994 Part 1: Recommended main dimensions; ISO 3914-2:1994 Part 2: Dimensions, tolerances and designation of tubes for open-end spinning machines
In mechanical engineering, a shaft is a rotating machine element, usually circular in cross section, which is used to transmit power from one part to another, ...