Search results
Results from the WOW.Com Content Network
A thousandth of an inch is a derived unit of length in a system of units using inches.Equal to 1 ⁄ 1000 of an inch, a thousandth is commonly called a thou / ˈ θ aʊ / (used for both singular and plural) or, particularly in North America, a mil (plural mils).
Alternatively, and for greater numbers, one may say for 1 ⁄ 2 "one over two", for 5 ⁄ 8 "five over eight", and so on. This "over" form is also widely used in mathematics. Fractions together with an integer are read as follows: 1 + 1 ⁄ 2 is "one and a half" 6 + 1 ⁄ 4 is "six and a quarter" 7 + 5 ⁄ 8 is "seven and five eighths"
For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...
1024 = 32 2 = 4 5 = 2 10, the number of bytes in a kilobyte (in 1999, the IEC coined kibibyte to use for 1024 with kilobyte being 1000, but this convention has not been widely adopted). 1024 is the smallest 4-digit square and also a Friedman number.
5.067 × 10 −4 square millimetres; 506.7 μm 2; 1000 circular mils = 1 MCM or 1 kcmil, and is (approximately) equal to: 0.5067 mm 2, so 2 kcmil ≈ 1 mm 2 (a 1.3% error) Therefore, for practical purposes such as wire choice, 2 kcmil ≈ 1 mm 2 is a reasonable rule of thumb for many applications.
A list of articles about numbers (not about numerals). Topics include powers of ten, notable integers, prime and cardinal numbers, and the myriad system.
This system results in "two thirds" for 2 ⁄ 3 and "fifteen thirty-seconds" for 15 ⁄ 32. This system is normally used for denominators less than 100 and for many powers of 10 . Examples include "six ten-thousandths" for 6 ⁄ 10,000 and "three hundredths" for 0.03.
Any real number can be written in the form m × 10 ^ n in many ways: for example, 350 can be written as 3.5 × 10 2 or 35 × 10 1 or 350 × 10 0. In normalized scientific notation (called "standard form" in the United Kingdom), the exponent n is chosen so that the absolute value of m remains at least one but less than ten ( 1 ≤ | m | < 10 ).