enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. The 7 Best HDTV Antenna Amplifiers of 2023 For a Better Signal

   www.aol.com/lifestyle/best-high-definition-tv...

   8-Port TV Distribution Amplifier. For households with multiple TVs, the Antennas Direct 8-Port TV Distribution Amplifier can split a signal with no noticeable impact on signal quality.

3. Antenna amplifier - Wikipedia

   en.wikipedia.org/wiki/Antenna_amplifier

   In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...

4. Television antenna - Wikipedia

   en.wikipedia.org/wiki/Television_antenna

   The television broadcast bands are too wide in frequency to be covered by a single antenna, so the two options are separate antennas used for the VHF and UHF bands or a combination (combo) VHF/UHF antenna. [6] A VHF/UHF antenna combines two antennas feeding the same feedline mounted on the same support boom.

5. SMATV - Wikipedia

   en.wikipedia.org/wiki/SMATV

   It provides Reception of DBS TV/FM channels for hotels, motels, dormitories, schools, hospitals and commercial properties with multiple tenants. Using a master antenna system video signals, audio signals and decoder signals can also be distributed. It consists of single outdoor unit or antenna feeding to number of indoor units. [3]

6. ATSC tuner - Wikipedia

   en.wikipedia.org/wiki/ATSC_tuner

   Canada had a similar analog TV termination date set to September 1, 2011 (except in some remote northern regions). [citation needed] It was feared that the US switch-off would cause millions of non-cable- and non-satellite-connected TV sets to "go dark". Viewers who did not upgrade, either to a television with a digital tuner or a set-top box ...

7. Analog television - Wikipedia

   en.wikipedia.org/wiki/Analog_television

   The audio signal goes to a 4.5 MHz amplifier. This amplifier prepares the signal for the 4.5 MHz detector. It then goes through a 4.5 MHz IF transformer to the detector. In television, there are 2 ways of detecting FM signals. One way is by the ratio detector. This is simple but very hard to align. The next is a relatively simple detector.