Search results
Results from the WOW.Com Content Network
A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters.
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.
An engine test stand is a facility used to develop, characterize and test engines. The facility, often offered as a product to automotive OEMs , allows engine operation in different operating regimes and offers measurement of several physical variables associated with the engine operation.
For this inline-4 engine, 1-3-4-2 could be a valid firing order.. The firing order of an internal combustion engine is the sequence of ignition for the cylinders.. In a spark ignition (e.g. gasoline/petrol) engine, the firing order corresponds to the order in which the spark plugs are operated.
Until the early 20th century, blow-by gases escaped from the crankcase by leaking through seals and gaskets. It was considered normal for oil to leak from an engine and drip onto the ground, as this had also been the case for steam engines in the decades before.
Crankshaft, pistons and connecting rods for a typical internal combustion engine Marine engine crankshafts from 1942. The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3] The up-down motion of each piston is transferred to the crankshaft via connecting ...
The cold-cranking simulator (CCS) is a device used to determine the low temperature performance of lubricants, when starting a cold engine (i.e. cold-cranking).In this condition, the only energy available to turn the engine comes from the starter motor and the battery, and it has been widely assumed that the system acts as a constant power viscometer.
Bantam Jeep Karl Probst (October 20, 1883 – August 25, 1963) was an American freelance engineer and automotive pioneer, credited with drafting the design drawings of the first prototype of the Bantam Reconnaissance Car, also known as the World War II "jeep" in 1940.