Search results
Results from the WOW.Com Content Network
A crowbar circuit is an electrical circuit used for preventing an overvoltage or surge condition of a power supply unit from damaging the circuits attached to the power supply. It operates by putting a short circuit or low resistance path across the voltage output (V o ), like dropping a crowbar across the output terminals of the power supply.
Circuit diagram of a simple Crowbar circuit, with an 8V nominal output (7.6V with SD1). ...
Circuit Diagram of a simple Crowbar Circuit, with an 8V nominal output (7.6V with SD1). Date: 06/05/06: Source: Own work, made in Livewire and Inkscape: Author: jjbeard:
When a circuit must be protected from overvoltage and there are failure modes in the power supply that can produce such overvoltages, the circuit may be protected by a device commonly called a crowbar circuit. When this device detects an overvoltage it causes a short circuit between the power supply and its return.
An inrush current limiter is a device or devices combination used to limit inrush current. Passive resistive components such as resistors (with power dissipation drawback), or negative temperature coefficient (NTC) thermistors are simple options while the positive one (PTC) is used to limit max current afterward as the circuit has been operating (with cool-down time drawback on both).
Although usually the result of a fault, there are cases where short circuits are caused intentionally, for example, for the purpose of voltage-sensing crowbar circuit protectors. In circuit analysis, a short circuit is defined as a connection between two nodes that forces them to be at the same voltage. In an 'ideal' short circuit, this means ...
Trisil is a trade name for a thyristor surge protection device, an electronic component designed to protect electronic circuits against overvoltage. Unlike a transient voltage suppression diodes, such as Transil, a Trisil acts as a crowbar device, switching ON when the voltage on it exceeds its breakover voltage.
This is common in simple phase angle controls for AC lamp dimmers and motor speed controls. They may also be used to sense over-voltage fault conditions to provide a 'crowbar' function to operate a fuse or a latching alarm that can only be reset by removing the supply.