Search results
Results from the WOW.Com Content Network
A 3800 Series II L67 Supercharged V6 engine in a 1998 Buick Regal GS. The L67 is the supercharged version of the 3800 Series II L36 and appeared in 1996, one year after the naturally aspirated version. It uses the Eaton Generation III M90 supercharger with a 3.8 in (97 mm) pulley, a larger throttle body, different fuel injectors, different ...
The fourth-generation Chevrolet Camaro is a pony car that was produced by American automobile manufacturer General Motors for the 1993 through 2002 model years. It was introduced on an updated F-body platform but retained the same characteristic since the first-generation's introduction back in 1967: two doors, coupe or convertible bodystyles, rear-wheel drive, and a choice of 6-cylinder and ...
A heavy-duty 4T60-E HD was produced in 1996 for the supercharged GM 3800 engine and reused in mid 2005 to 2009 with an LS4 5.3 liter V8 in four different models the Buick Lacrosse Super, Chevrolet Impala SS, Chevrolet Monte Carlo SS, and Pontiac Grand Prix GXP. The 4T60-E was phased out in favor of the 4T65 beginning in 1997.
For 1993 to 1995, the V6 was the 3.4 L (208 cu in) 60°; 1996–2002 cars received the 3.8L (231 cu in) 3800 Series II V6. 1993–1997 V8 cars shipped with the 5.7L (350 cu in) LT1, while 1998–2002 cars received the 5.7L (346 cu in) LS1. Both engines were available with the 4L60E four-speed automatic transmission.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
This engine, in 3800 Series II form, was an option on the SE with 195 horsepower. The 3800 Series II was on the Ward's 10 Best Engines list for 1995–1997. Replacing the Chevy LQ1 3.4 L DOHC V6, an Eaton M90 supercharger option was available on the 3.8 L from 1997 to 2003 (also used in the 1996–2003 Bonneville), with compression ratio ...
These engines vary in displacement between 2.8 and 3.4 litres (2,837 and 3,350 cc) and have a cast-iron block and either cast-iron or aluminum heads. Production of these engines began in 1980 and ended in 2005 in the U.S., with production continued in China until 2010. This engine family was the basis for the GM High Value engine family.
The Chevrolet 90° V6 family of V6 engines began in 1978 with the Chevrolet 200 cu in (3.3 L) as the base engine for the all new 1978 Chevrolet Malibu.The original engine family was phased out in early 2014, with its final use as the 4.3 L (262 cu in) V6 engine used in Chevrolet and GMC trucks and vans.