enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Countersink - Wikipedia

   en.wikipedia.org/wiki/Countersink

   In manufacturing, a countersink (symbol: ⌵) is a conical hole cut into a manufactured object, or the cutter used to cut such a hole. A common use is to allow the head of a countersunk bolt , screw or rivet , when placed in the hole, to sit flush with or below the surface of the surrounding material (by comparison, a counterbore makes a flat ...

3. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Countersinks for countersunk head screws (except screws with DIN EN 27721 head) Active: DIN 76-1: Thread run-outs and thread undercuts for ISO metric threads in accordance with DIN 13-1: Active: DIN 76-2: Thread run-outs and thread undercuts for pipe threads conforming to ISO 228 part 1: Active: DIN 76-3

4. Barrel threads - Wikipedia

   en.wikipedia.org/wiki/Barrel_threads

   3.8 mm depth countersink for the bolt head with a 17.9 mm diameter ... Also written as 1.120"-20 1-1/8"-20 Savage 110 (short magnum), [5] ... Inch M12.7 0.907 mm ...

5. List of the United States Army weapons by supply catalog ...

   en.wikipedia.org/wiki/List_of_the_United_States...

   Ordnance crest "WHAT'S IN A NAME" - military education about SNL. This is a historic (index) list of United States Army weapons and materiel, by their Standard Nomenclature List (SNL) group and individual designations — an alpha-numeric nomenclature system used in the United States Army Ordnance Corps Supply Catalogues used from about 1930 to about 1958.

6. List of ISO standards 3000–4999 - Wikipedia

   en.wikipedia.org/wiki/List_of_ISO_standards_3000...

   ISO 3294:2016 Parallel shank countersinks for angles 60, 90 and 120 degrees inclusive ISO 3295:1975 Narrow bandsaw blades for woodworking — Dimensions ISO 3296:1975 Textile machinery and accessories — Tubes for ring-spinning, doubling and twisting spindles, taper 1:64 [Withdrawn: replaced with ISO 368]

7. Counterbore - Wikipedia

   en.wikipedia.org/wiki/Counterbore

   Whereas a counterbore is a flat-bottomed enlargement of a smaller coaxial hole, a countersink is a conical enlargement of such. A spotface often takes the form of a very shallow counterbore. As mentioned above, the cutters that produce counterbores are often also called counterbores; sometimes, to avoid ambiguity, the term counterbore cutter is ...

8. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Flat-blade jeweler's screwdrivers and the tips found in 1 ⁄ 4-inch or 6.4-millimeter drive sets are generally hollow-ground. Note that it is this typical chisel shape which allows 9 screwdriver sizes to drive 24 different slotted screw sizes, with the drawbacks of not fitting as closely as a hollow-ground screwdriver would, and increasing the ...

9. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   In the US, BSW was replaced when steel bolts replaced iron, but was still being used for some aluminium parts as late as the 1960s and 1970s when metric-based standards International Inch replaced the U.S. inch and U.K. inch in 1951-1964. [citation needed] American Unified Coarse (UNC) was originally based on almost the same Imperial fractions ...