enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bi-pin lamp base - Wikipedia

   en.wikipedia.org/wiki/Bi-pin_lamp_base

   The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...

3. GU24 lamp fitting - Wikipedia

   en.wikipedia.org/wiki/GU24_lamp_fitting

   The GU24 fitting is intended to maintain the energy efficiency of the light by preventing an occupant from using an incandescent bulb instead of a CFL. Adapters to use incandescent bulbs in a GU24 fitting are illegal in the State of California as they would be a fire hazard in fixtures designed for the lower heat output of a CFL bulb. [2]

4. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

5. Lightbulb socket - Wikipedia

   en.wikipedia.org/wiki/Lightbulb_socket

   GY6.35 & GZ6.35 – same as G6.35 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G8 – 8 mm (0.31496 in) pin spacing GU8 – same as G8 and only denotes what lamp mount clip is needed to hold the actual light bulb in place; GY8.6 – 8.6 mm (0.33858 in) pin spacing; G9 – 9 mm (0.35433 in) pin spacing

6. Dimmer - Wikipedia

   en.wikipedia.org/wiki/Dimmer

   To house this device, he decided on a 2-inch round device with one end capable of being screwed into a light bulb socket and the other end able to receive a light bulb. [4] When solid-state dimmers came into use, analogue remote control systems (such as 0-10 V lighting control systems) became feasible. The wire for the control systems was much ...

7. Wedge base - Wikipedia

   en.wikipedia.org/wiki/Wedge_base

   In Europe, bulbs using wedge base connectors are often referred to by the designations the World Forum for Harmonization of Vehicle Regulations has assigned to them, like P27/7W for W2.5x16q when used as a combined 27 and 7 watt light bulb intended for position, brake and turn lights in vehicles.

8. Light-emitting diode - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode

   Efficiency: LEDs emit more lumens per watt than incandescent light bulbs. [63] The efficiency of LED lighting fixtures is not affected by shape and size, unlike fluorescent light bulbs or tubes. Size: LEDs can be very small (smaller than 2 mm 2 [64]) and are easily attached to printed circuit boards.

9. Mogul lamp - Wikipedia

   en.wikipedia.org/wiki/Mogul_lamp

   Compact fluorescent mogul-base bulbs are also available, as are adaptors to allow medium-base bulbs to be used in mogul sockets. There are usually two three-way switches near the top of the floor lamp to operate the bulbs. One controls the three-way center bulb, and the other turns on one, two, or all three (or four) of the peripheral bulbs.