enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Differential (mechanical device) - Wikipedia

   en.wikipedia.org/wiki/Differential_(mechanical...

   A spur-gear differential has equal-sized spur gears at each end, each of which is connected to an output shaft. [8] The input torque (i.e. from the engine or transmission) is applied to the differential via the rotating carrier. [8] Pinion pairs are located within the carrier and rotate freely on pins supported by the carrier.

3. GM 10.5-inch 14-bolt differential - Wikipedia

   en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

   Its nomenclature, "14-bolt," represents the 14 bolts securing the differential cover, although the ring gear itself is fastened by 12 bolts. Notably, the 14-bolt differential gained traction among Jeep Wrangler owners seeking axle replacement options, [ 2 ] earning the moniker "corporate" 14-bolt because of its association with GM's corporate ...

4. Starter ring gear - Wikipedia

   en.wikipedia.org/wiki/Starter_ring_gear

   A starter ring gear is a part attached to an internal combustion engine that is part of the assembly which transfers the torque from the starter motor to the engine's crankshaft, in order to start the engine. The starter ring gear is usually made from medium carbon steel. Starter ring gears are attached to either the flywheel or the flexplate ...

5. List of gear nomenclature - Wikipedia

   en.wikipedia.org/wiki/List_of_gear_nomenclature

   A face gear set typically consists of a disk-shaped gear, grooved on at least one face, in combination with a spur, helical, or conical pinion. A face gear has a planar pitch surface and a planar root surface, both of which are perpendicular to the axis of rotation. [ 1 ]

6. Bendix drive - Wikipedia

   en.wikipedia.org/wiki/Bendix_drive

   A Bendix drive is a type of engagement mechanism used in starter motors of internal combustion engines.The device allows the pinion gear of the starter motor to engage or disengage the ring gear (which is attached to the flywheel or flexplate of the engine) automatically when the starter is powered or when the engine fires, respectively.

7. Dana 35 - Wikipedia

   en.wikipedia.org/wiki/Dana_35

   Gear Ratios for the Jeep YJ were 3.07:1, 3.54:1, 3.73:1 and 4.10:1 Axle Shaft diameter: 1.09 inches (28 mm) (30 Spline) Ring and Pinion gear sets for Jeep Dana 35 rear applications can be used in Ford Ranger IFS (Dana 35) front axles.