enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Convergence (routing) - Wikipedia

    en.wikipedia.org/wiki/Convergence_(routing)

    Convergence is the state of a set of routers that have the same topological information about the internetwork in which they operate. For a set of routers to have converged, they must have collected all available topology information from each other via the implemented routing protocol, the information they gathered must not contradict any other router's topology information in the set, and it ...

  3. Default gateway - Wikipedia

    en.wikipedia.org/wiki/Default_gateway

    The IP-address could be 91.198.174.2. In this example, none of the internal routers know the route to that host, so they will forward the packet through router1's gateway or default route. [1] Every router on the packet's way to the destination will check whether the packet's destination IP-address matches any known network routes. If a router ...

  4. Converge ICT - Wikipedia

    en.wikipedia.org/wiki/Converge_ICT

    Converge was established in 1996 as the ComClark Network and Technology Corp. by Dennis Anthony Uy in 1996 at Angeles City. [4]In 2009, the Congress of the Philippines enacted Republic Act No. 9707, to grant Converge ICT Solutions Inc. the franchise to construct, install, establish, operate, and maintain a telecommunication system throughout the Philippines.

  5. Default route - Wikipedia

    en.wikipedia.org/wiki/Default_route

    The route evaluation process in each router uses the longest prefix match method to obtain the most specific route. The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the ...

  6. Open Shortest Path First - Wikipedia

    en.wikipedia.org/wiki/Open_Shortest_Path_First

    NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.

  7. IP routing - Wikipedia

    en.wikipedia.org/wiki/IP_routing

    The IP forwarding algorithm is a specific implementation of routing for IP networks. In order to achieve a successful transfer of data, the algorithm uses a routing table to select a next-hop router as the next destination for a datagram. The IP address of the selected router is known as the next-hop address. [1] The IP forwarding algorithm ...

  8. IP address - Wikipedia

    en.wikipedia.org/wiki/IP_address

    A public IP address is a globally routable unicast IP address, meaning that the address is not an address reserved for use in private networks, such as those reserved by RFC 1918, or the various IPv6 address formats of local scope or site-local scope, for example for link-local addressing. Public IP addresses may be used for communication ...

  9. RDMA over Converged Ethernet - Wikipedia

    en.wikipedia.org/wiki/RDMA_over_Converged_Ethernet

    RDMA over Converged Ethernet (RoCE) [1] is a network protocol which allows remote direct memory access (RDMA) over an Ethernet network. There are multiple RoCE versions. RoCE v1 is an Ethernet link layer protocol and hence allows communication between any two hosts in the same Ethernet broadcast domain.