Search results
Results from the WOW.Com Content Network
Convergence is the state of a set of routers that have the same topological information about the internetwork in which they operate. For a set of routers to have converged, they must have collected all available topology information from each other via the implemented routing protocol, the information they gathered must not contradict any other router's topology information in the set, and it ...
The primary function of a router is to forward a packet toward its destination network, which is the destination IP address of the packet. To do this, a router needs to search the routing information stored in its routing table. The routing table contains network/next hop associations. These associations tell a router that a particular ...
A wildcard mask is a mask of bits that indicates which parts of an IP address are available for examination. In the Cisco IOS, [1] they are used in several places, for example: To indicate the size of a network or subnet for some routing protocols, such as OSPF. To indicate what IP addresses should be permitted or denied in access control lists ...
The IP forwarding algorithm is a specific implementation of routing for IP networks. In order to achieve a successful transfer of data, the algorithm uses a routing table to select a next-hop router as the next destination for a datagram. The IP address of the selected router is known as the next-hop address. [1] The IP forwarding algorithm ...
76 ZTE. 77 Other digital ... IP Office 400 (SOE, 403, 406, 406v2, 412), Replaced by IP Office 500 ... The first example of this switch was installed for Bell Canada ...
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
Each 1-bit denotes a bit of the address range which must remain identical to the given IP address. The IP address in CIDR notation is always represented according to the standards for IPv4 or IPv6. The address may denote a specific interface address (including a host identifier, such as 10.0.0.1 / 8), or it may be the beginning address of an ...
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.