Search results
Results from the WOW.Com Content Network
The C4 was designed to be a lighter and simpler replacement for the original Ford-O-Matic two speed transmission being used in smaller, less powerful cars. Ford used the term "SelectShift" because in the first C4's, placing the gear selector in D2 forced the transmission to start in second gear and then shift to third gear.
Ford-O-Matic was the first automatic transmission widely used by Ford Motor Company. [2] It was designed by the Warner Gear division of Borg Warner Corporation and introduced in 1951 model year cars, and was called the Merc-O-Matic when installed in Mercury branded cars and Turbo-Drive when installed in Lincoln branded cars. [2]
The Borg-Warner 35 transmission (BW-35) is an automatic transmission produced by the BorgWarner company. This article also applies to variations—the M-36 and M-37. When this article refers to "M-3x" it refers to all models. When model number specific it will use the exact model number. The "3" in the number refers to the specific series of ...
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
The Ford C6 is a heavy-duty automatic transmission built by Ford Motor Company between 1966 and 2004. It was marketed as the "SelectShift Cruise-O-Matic." Compared to its predecessor MX transmission, the C6 offered lower weight, less complexity, less parasitic power loss, and greater torque capacity for larger engines.
As technology progressed, it was replaced by a modern ZF 6-speed manual transmission. However, the C4's performance was hampered by its L98 250 hp (186 kW) engine until 1992, [7] when the second-generation Chevy small block, the 300 hp (224 kW) LT1, was introduced, markedly improving the C4's performance. 1996 was a high point of small block ...
The 1941 Chrysler M4 Vacamatic transmission was a two-speed manual transmission with an integral underdrive unit, a traditional manual clutch, and a fluid coupling between the engine and the clutch. [51] [52] [53] The two-speed transmission had "high" and "low" ranges, and the clutch was used when the driver wanted to switch between ranges. For ...
A mechanical transmission with a selection of different gear ratios is designed to make satisfactory power available over the full range of vehicle speeds. The goal of the selection of gear ratios is to keep the engine operating in its power band. The narrower the band, the more gears are needed, closer together in ratio.