Ads
related to: 7-16 20 boltboltdepot.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
British Standard Whitworth. British Standard Whitworth (BSW) is an imperial-unit -based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF, BSP, BSCon, and BSCopper.
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
Unified Thread Standard. The Unified Thread Standard (UTS) defines a standard thread form and series—along with allowances, tolerances, and designations—for screw threads commonly used in the United States and Canada. It is the main standard for bolts, nuts, and a wide variety of other threaded fasteners used in these countries.
In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...
British Standard Fine (BSF) is a screw thread form, as a fine-pitch alternative to British Standard Whitworth (BSW) thread. It was used for steel bolts and nuts on and in much of Britain's machinery, including cars, prior to adoption of Unified, and later Metric, standards. For highly stressed conditions, especially in motorcycles, a finer ...
The drawbar thread is typically 7 ⁄ 16 ″–20 tpi . The angle of the cone is 16°51′ (16.85°) with an OD of 1.25″ and a length of 15 ⁄ 16 ″. [ 21 ] (source, Bridgeport Manufacturer) The diameter of the parallel locating portion is not a "fractional inch" size like the other dimensions and is 0.949″ to 0.9495″.
Ads
related to: 7-16 20 boltboltdepot.com has been visited by 10K+ users in the past month