Search results
Results from the WOW.Com Content Network
Hochberg's step-up procedure (1988) is performed using the following steps: [8] Start by ordering the p-values (from lowest to highest) () … and let the associated hypotheses be …
A hypothesis is rejected at level α if and only if its adjusted p-value is less than α. In the earlier example using equal weights, the adjusted p-values are 0.03, 0.06, 0.06, and 0.02. This is another way to see that using α = 0.05, only hypotheses one and four are rejected by this procedure.
Fisher's exact test is a statistical significance test used in the analysis of contingency tables. [1][2][3] Although in practice it is employed when sample sizes are small, it is valid for all sample sizes. It is named after its inventor, Ronald Fisher, and is one of a class of exact tests, so called because the significance of the deviation ...
p. -value. In null-hypothesis significance testing, the -value[note 1] is the probability of obtaining test results at least as extreme as the result actually observed, under the assumption that the null hypothesis is correct. [2][3] A very small p -value means that such an extreme observed outcome would be very unlikely under the null hypothesis.
False discovery rate. In statistics, the false discovery rate (FDR) is a method of conceptualizing the rate of type I errors in null hypothesis testing when conducting multiple comparisons. FDR-controlling procedures are designed to control the FDR, which is the expected proportion of "discoveries" (rejected null hypotheses) that are false ...
The partition coefficient, abbreviated P, is defined as a particular ratio of the concentrations of a solute between the two solvents (a biphase of liquid phases), specifically for un- ionized solutes, and the logarithm of the ratio is thus log P. [10]: 275ff When one of the solvents is water and the other is a non-polar solvent, then the log P ...
Fisher's method combines extreme value probabilities from each test, commonly known as " p -values ", into one test statistic (X2) using the formula. where pi is the p -value for the ith hypothesis test. When the p -values tend to be small, the test statistic X2 will be large, which suggests that the null hypotheses are not true for every test.
The Bonferroni correction can also be applied as a p-value adjustment: Using that approach, instead of adjusting the alpha level, each p-value is multiplied by the number of tests (with adjusted p-values that exceed 1 then being reduced to 1), and the alpha level is left unchanged. The significance decisions using this approach will be the same ...