Search results
Results from the WOW.Com Content Network
ADTRAN/BlueSocket; Aerohive Networks - acquired by Extreme Networks [1]; Alaxala Networks; Alcatel-Lucent Enterprise; Allied Telesis; Alvarion; Aruba - acquired by HPE; Asus; Avaya; AVM; Belkin
This is an Accton Etherpocket-SP parallel port Ethernet adapter (c. 1990). Supports both coaxial and twisted pair cables. Power is drawn from a PS/2 port passthrough cable. Before the introduction of the PCMCIA card, the parallel port was commonly used for portable peripherals. [6]
12 V and 24 V powered USB sockets, on an NCR cash register. PoweredUSB, also known as Retail USB, USB PlusPower, USB +Power, and USB Power Plus, [1] is an addition to the Universal Serial Bus standard that allows for higher-power devices to obtain power through their USB host instead of requiring an independent power supply or external AC adapter.
Power over Ethernet (PoE) describes any of several standards or ad hoc systems that pass electric power along with data on twisted-pair Ethernet cabling. This allows a single cable to provide both a data connection and enough electricity to power networked devices such as wireless access points (WAPs), IP cameras and VoIP phones .
The specification also allows USB PD ports to provide even greater power at higher voltages over PD-aware cables – up to 36 W at 12 V and 60 W at 20 V (for micro-USB connectors) and up to 60 W at 12 V and 100 W at 20 V (for standard USB A/B connectors). [12] The 12-inch 2015 MacBook uses a USB-C port for charging
Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...
These are referred to as MDI and MDI-X (medium-dependent interface crossover). When connecting an MDI port to an MDI-X port, a straight-through cable is used, while to connect two MDI ports or two MDI-X ports, a crossover cable must be used. Conventionally, MDI is used on end devices and routers while MDI-X is used on hubs and switches.
The +12 V supply was used for computer fan motors, disk drive motors and serial interfaces (which also used the −12 V supply). A further use of the 12 V came with the sound cards, using linear chip audio power amplifiers, sometimes filtered by a 9 V linear regulator on the card to cut the noise of the motors.