enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Resin casting - Wikipedia

   en.wikipedia.org/wiki/Resin_casting

   Specialist equipment can enable closed molds to be filled whilst under vacuum, a process known as resin vacuum casting, where air and gas bubbles are completely removed from the cast part. Pressure and/or centrifugal force can be used to help push the liquid resin into all details of the mold. The mold can also be vibrated to expel bubbles.

3. Poly(methyl methacrylate) - Wikipedia

   en.wikipedia.org/wiki/Poly(methyl_methacrylate)

   PMMA is also known as acrylic, acrylic glass, as well as by the trade names and brands Crylux, Hesalite, Plexiglas, Acrylite, Lucite, and Perspex, among several others . This plastic is often used in sheet form as a lightweight or shatter-resistant alternative to glass. It can also be used as a casting resin, in inks and coatings, and for many ...

4. Casting - Wikipedia

   en.wikipedia.org/wiki/Casting

   Plaster and other chemical curing materials such as concrete and plastic resin may be cast using single-use waste molds as noted above, multiple-use 'piece' molds, or molds made of small rigid pieces or of flexible material such as latex rubber (which is in turn supported by an exterior mold). When casting plaster or concrete, the material ...

5. Acrylic resin - Wikipedia

   en.wikipedia.org/wiki/Acrylic_resin

   Acrylic resin is a common ingredient in latex paint (UK: "emulsion paint"). Latex paints with a greater proportion of acrylic resin offer better stain protection, greater water resistance, better adhesion, greater resistance to cracking and blistering, and resistance to alkali cleaners compared to those with vinyl. [2]

6. Molding (process) - Wikipedia

   en.wikipedia.org/wiki/Molding_(process)

   A mold or mould is a hollowed-out block that is filled with a liquid or pliable material such as plastic, glass, metal, or ceramic raw material. [2] The liquid hardens or sets inside the mold, adopting its shape. A mold is a counterpart to a cast. The very common bi-valve molding process uses two molds, one for each half of the object.

7. Polymer solution casting - Wikipedia

   en.wikipedia.org/wiki/Polymer_solution_casting

   The polymer solution casting process utilizes a mandrel, or inner diameter mold, that is immersed in a tank of polymer solution or liquid plastic that has been specifically engineered for the process. Due to a combination of thermal and frictional properties, the polymer solution then forms a thin film around the mold. [1]