Search results
Results from the WOW.Com Content Network
The driving point impedance of a half-wave folded dipole is 4 times that of a simple half-wave dipole, thus closely matching that 300 Ω characteristic impedance. [19] [full citation needed] Most FM broadcast band tuners and older analog televisions include balanced 300 Ω antenna input terminals. However twin lead has the drawback that it is ...
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
When the antenna is fed at some other point, the formula requires a correction factor discussed below. In a receiving antenna the radiation resistance represents the source resistance of the antenna, and the portion of the received radio power consumed by the radiation resistance represents radio waves re-radiated (scattered) by the antenna. [8 ...
The most common type of dipole consists of two resonant elements, each just under a quarter wavelength long, hence a total length of about a half-wave. This antenna radiates maximally in directions perpendicular to the antenna's axis, giving it a small directive gain of 2.15 dBi (2.15 dBi means that in the direction of maximum radiation, signal ...
So the element has a node of the current standing wave at both top and bottom, it is equivalent to an end-fed vertical dipole antenna (so some sources do not call this antenna a monopole [65]). The resonant frequencies can be calculated by a derivation similar to that in the previous section, but it is easier to note that a standing wave has a ...
A Yagi–Uda antenna, or simply Yagi antenna, is a directional antenna consisting of two or more parallel resonant antenna elements in an end-fire array; [1] these elements are most often metal rods (or discs) acting as half-wave dipoles. [2] Yagi–Uda antennas consist of a single driven element connected to a radio transmitter or receiver (or ...
The driven element of the antenna is usually a half-wave dipole, its length half a wavelength of the radio waves used. The parasitic elements are of two types. A "reflector" is slightly longer (around 5%) than a half-wavelength. It serves to reflect the radio waves in the opposite direction.