enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Blowoff valve - Wikipedia

    en.wikipedia.org/wiki/Blowoff_valve

    A blowoff valve (also called dump valve or compressor bypass valve) is a pressure release system present in most petrol turbocharged engines. Blowoff valves are used to reduce pressure in the intake system as the throttle is closed, thus preventing compressor surge .

  3. Fuel injection - Wikipedia

    en.wikipedia.org/wiki/Fuel_injection

    Prior to 1979, the electronics in fuel injection systems used analogue electronics for the control system. The Bosch Motronic multi-point fuel injection system (also amongst the first systems where the ignition system is controlled by the same device as the fuel injection system) was the first mass-produced system to use digital electronics.

  4. Air-blast injection - Wikipedia

    en.wikipedia.org/wiki/Air-blast_injection

    A separate cam on the camshaft (as seen in Fig. 5 and on the two-cylinder Johann-Weitzer-engine on the right) would activate the injection valve so the compressed air would then press the fuel into the combustion chamber. Before the injection valve opens, neither fuel nor compressed air can enter the combustion chamber. [16]

  5. Naturally aspirated engine - Wikipedia

    en.wikipedia.org/wiki/Naturally_aspirated_engine

    In a naturally aspirated engine, air for combustion (Diesel cycle in a diesel engine or specific types of Otto cycle in petrol engines, namely petrol direct injection) or an air/fuel mixture (traditional Otto cycle petrol engines), is drawn into the engine's cylinders by atmospheric pressure acting against a partial vacuum that occurs as the piston travels downwards toward bottom dead centre ...

  6. Crankcase ventilation system - Wikipedia

    en.wikipedia.org/wiki/Crankcase_ventilation_system

    This is due to the fact that the fuel hits the intake valves on the way to the combustion chamber, allowing the detergents in the fuel to keep them clean. However, carbon build-up on intake valves is a problem for engines with direct injection only, as the fuel is injected directly into the combustion chamber.

  7. Manifold injection - Wikipedia

    en.wikipedia.org/wiki/Manifold_injection

    Manifold injection is a mixture formation system for internal combustion engines with external mixture formation. It is commonly used in engines with spark ignition that use petrol as fuel, such as the Otto engine, and the Wankel engine.

  8. Anti-dribble valve - Wikipedia

    en.wikipedia.org/wiki/Anti-dribble_valve

    These valves are mounted on the outlet fittings of the fuel injection pump, one per cylinder injector. They are always mounted at the pump end of the pipes between the pump and injectors. The check valve aspect is a conical valve or 'mitre valve', [i] held against a matching conical seat by a spring. As these valves must work at high pressure ...

  9. Idle air control actuator - Wikipedia

    en.wikipedia.org/wiki/Idle_air_control_actuator

    An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.