Search results
Results from the WOW.Com Content Network
A raised increase, knitting into row below (k-b, k 1 b) A lifted increase, knitting into the yarn between the stitches (inc, m1) Knit front and back (kfb) Purl front and back (, pass slipped stitch over (S1, K1, PSSO) for a left-leaning decrease. Knit two together through the back loops (K2tog tbl) for a left-leaning decrease.
Fair Isle knitting gained considerable popularity when the Prince of Wales (later King Edward VIII) wore Fair Isle jumpers in public in 1921. Traditional Fair Isle patterns have a limited palette of five or so colours, use only two colours per row, are worked in the round, and limit the length of a run of any particular colour. [1]
Bring the needle in front of the thumb, under both yarns around the thumb, down into the center of the thumb loop, back forward, and over the top of the yarn around the index finger. Use the needle to catch this yarn, then bring the needle back down through the thumb loop, turning the thumb slightly to make room for the needle to pass through.
If the fabric is being knit back-and-forth, turned after every row, the effect is produced even more simply by knitting each row—first from the right side, then from the wrong side. Similar to ribbing , a welting pattern can be specified by the number of knit rows followed by the number of purl rows, e.g., 1x1 welting is garter stitch.
There are also different ways to insert the needle into the stitch. Knitting through the front of a stitch is called Western knitting. Going through the back of a stitch is called Eastern knitting. A third method, called combination knitting, goes through the front of a knit stitch and the back of a purl stitch. [6]
Gathers knit into a pullover sweater using stitch decreases.. In knitting, a gather draws stitches closer together within a row of knitting. Common methods include: In binding, a yarn loop is passed over 2 or more stitches in the same row (usually adjacent to the binding loop); also known as a pullover stitch.
A ribbed scarf hand-knit with a pattern that uses short rows. In knitting, a short row is a row that is not fully knitted; the work is turned before reaching the end of the row. When working short rows, technique must be employed to prevent holes or gaps where the work is turned.
Rather than use a cable needle, some knitters prefer to use a large safety pin or, for a single stitch, simply hold it in their fingers while knitting the other stitch(es). Cabling is typically done only when working on the right side of the fabric, i.e., every other row. This creates a spacer row, which helps the fabric to relax.