Search results
Results from the WOW.Com Content Network
For example, a 900-watt power supply with the 80 Plus Silver efficiency rating (which means that such a power supply is designed to be at least 85% efficient for loads above 180 W) may only be 73% efficient when the load is lower than 100 W, which is a typical idle power for a desktop computer. Thus, for a 100 W load, losses for this supply ...
1.12×10 36: Estimated computational power of a Matrioshka brain, assuming 1.87×10 26 watt power produced by solar panels and 6 GFLOPS/watt efficiency. [ 21 ] 4×10 48 : Estimated computational power of a Matrioshka brain whose power source is the Sun , the outermost layer operates at 10 kelvins , and the constituent parts operate at or near ...
A change of one bel in the level corresponds to a 10× change in power, so when comparing power quantities x and y, the difference is defined to be 10×log 10 (y/x) decibel. With root-power quantities, however the difference is defined as 20×log 10 (y/x) dB. [3]
The power measurement is often the average power used while running the benchmark, but other measures of power usage may be employed (e.g. peak power, idle power). For example, the early UNIVAC I computer performed approximately 0.015 operations per watt-second (performing 1,905 operations per second (OPS), while consuming 125 kW).
A modern computer power supply is a switch-mode power supply that converts AC power from the mains supply, to several DC voltages. Switch-mode supplies replaced linear supplies due to cost, weight, efficiency and size improvements. The diverse collection of output voltages also have widely varying current draw requirements.
COM-HPC Size D PICMG: 2020 160 × 160 mm (6.3 × 6.3 in) Used in embedded systems. Requires a carrier board. Typically used for COM-HPC Server Type modules with 4x full size DIMM memory sockets. COM-HPC Size E PICMG: 2020 200 × 160 mm (7.9 × 6.3 in) Used in embedded systems. Requires a carrier board.
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
This page was last edited on 7 December 2011, at 14:59 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.