enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Piping and instrumentation diagram - Wikipedia

   en.wikipedia.org/wiki/Piping_and_instrumentation...

   P&IDs are originally drawn up at the design stage from a combination of process flow sheet data, the mechanical process equipment design, and the instrumentation engineering design. During the design stage, the diagram also provides the basis for the development of system control schemes, allowing for further safety and operational ...

3. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   Some flexible duct markets prefer to avoid using flexible duct on the return air portions of HVAC systems, however flexible duct can tolerate moderate negative pressures. The UL181 test requires a negative pressure of 200 Pa. To use flexible ducting in a system, make sure to pull the duct tight so you get the full internal diameter.

4. Heating, ventilation, and air conditioning - Wikipedia

   en.wikipedia.org/wiki/Heating,_ventilation,_and...

   Warm air systems distribute the heated air through ductwork systems of supply and return air through metal or fiberglass ducts. Many systems use the same ducts to distribute air cooled by an evaporator coil for air conditioning. The air supply is normally filtered through air filters [dubious – discuss] to remove dust and pollen particles. [15]

5. Process duct work - Wikipedia

   en.wikipedia.org/wiki/Process_Duct_Work

   A major consideration of duct design is to minimize duct pressure losses, turbulence, as poor duct geometry, increases turbulence, and increases plant electrical usage. Round duct work suction pressure collapse, in ducts over 6 feet in diameter, is prevented with rings at supports, and roughly 3 diameter centers.

6. Ductwork airtightness - Wikipedia

   en.wikipedia.org/wiki/Ductwork_airtightness

   There are two major systems to classify ductwork airtightness, one based on European standards, the other based on ASHRAE standard 90.1-2010.Both are based on the leakage airflow rate at a given ductwork pressure divided by the product of the ductwork surface area and the same ductwork pressure raised to the power 0.65.

7. Underfloor air distribution - Wikipedia

   en.wikipedia.org/wiki/Underfloor_air_distribution

   The UFAD system was originally introduced in the 1950s for rooms with high heat loads and raised floors systems for cable and equipment management (e.g. computer rooms, control centers, etc.). The system was introduced into office buildings in the 1970s in West Germany, with the addition of occupant-controlled localized supply diffusers.