enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole saw - Wikipedia

   en.wikipedia.org/wiki/Hole_saw

   The bond materials welded diamond core drill bits usually are specially adjusted to fit the wet and dry drillings respectively. This can make the core bits perform better in drilling speed and/or lifespan. Diamond hole saws will drill through tile, porcelain tiles, granite, marble, concrete, metals and any lapidary material.

3. Ceramic tile cutter - Wikipedia

   en.wikipedia.org/wiki/Ceramic_tile_cutter

   First Tile Cutter Invented by Boada Brothers. The ceramic tile cutter works by first scratching a straight line across the surface of the tile with a hardened metal wheel and then applying pressure directly below the line and on each side of the line on top. Snapping pressure varies widely, some mass-produced models exerting over 750 kg.

4. Disc cutter - Wikipedia

   en.wikipedia.org/wiki/Disc_cutter

   Some discs used for cutting ceramic tile or stone are made from a solid disc with an edge coated with diamond grit. The most common size for these cutting wheels is 4 + 1 ⁄ 2 inches in diameter; however they can range from 2 to 16 inches in diameter with a thickness range from .045 in. to .125 in. Type 1 discs are flat, and type 27 discs have ...

5. Porcelain tile - Wikipedia

   en.wikipedia.org/wiki/Porcelain_tile

   Porcelain tiles or ceramic tiles are either tiles made of porcelain, or relatively tough ceramic tiles made with a variety of materials and methods, that are suitable for use as floor tiles, or for walls. They have a low water absorption rate, generally less than 0.5 percent. The clay used to build porcelain tiles is generally denser than ...

6. Diamond tool - Wikipedia

   en.wikipedia.org/wiki/Diamond_tool

   Ceramic-bonded diamond ... The main application of PCD drilling bits is in the oil and natural gas industries and the mining industry. ... porcelain tiles or granite ...

7. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   While the above is a common use of center drill bits, it is a technically incorrect practice and should not be considered for production use. The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The ...