Ad
related to: throttle linkage cable diagram pdf templateebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
A Bowden cable (/ ˈ b oʊ d ən / BOH-dən) [1] is a type of flexible cable used to transmit mechanical force or energy by the movement of an inner cable relative to a hollow outer cable housing. The housing is generally of composite construction, consisting of an inner lining, a longitudinally incompressible layer such as a helical winding or ...
Accelerate-by-wire or throttle-by-wire, [17] more commonly known as electronic throttle control, is a system that actuates vehicle propulsion without any mechanical connections, such as cables, from the accelerator pedal to the throttle valve of the engine or other propulsion systems. In electric vehicles, this system controls the electric ...
Historically, the throttle pedal or lever acts via a direct mechanical linkage. The butterfly valve of the throttle is operated by means of an arm piece, loaded by a spring. This arm is usually directly linked to the accelerator cable, and operates in accordance with the driver, who hits it.
A steel cable connected the accelerator pedal inside the vehicle to a mechanical linkage at the side of the throttle body, which acted to open the air intake butterfly valves inside the venturis. During idle these butterfly valves were closed, so a bypass port and the IAC valve were used to control the intake of air.
The stator blades moved from high to low position by an electrical solenoid and a stator valve, controlled by a switch on the throttle linkage. At light to medium throttle, the stator blades were at 32°, providing a torque multiplication of 1.8:1 and a converter stall speed of approximately 1800 rpm. At ⅔ to full throttle, the blades ...
a throttle lever or regulator, which controls the amount of steam entering the cylinders [3]: 75 : 82 a reversing lever or (US term) Johnson bar, which controls the timing of the admission of steam into the locomotive's cylinders. [3]: 65 This is required for two purposes. One is to reverse the locomotive's direction, e.g. when shunting.
Here, small valves were attached to the original control cables, controlling the flow of oil into an associated actuator connected to the control surface. One of the earliest fittings of a hydraulic boost system was to ailerons on late-war models of the P-38L, removing the need for great human strength to achieve a higher rate of roll.
Ad
related to: throttle linkage cable diagram pdf templateebay.com has been visited by 1M+ users in the past month