enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

3. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   Tapcon screws are a popular anchor that stands for self tapping (self threading) concrete screw. Larger diameter screws are referred to as LDT's. This type of fastener requires a pre-drilled hole—using a Tapcon drillbit—and are then screwed into the hole using a standard hex or phillips bit. These screws are often blue, white, or stainless ...

4. Torx - Wikipedia

   en.wikipedia.org/wiki/Torx

   A security Torx L-key and fastener with holes for a safety pin to hinder disassembly with an ordinary Torx key. A Torx T8 screw head on a hard disk drive.. Torx (pronounced / t ɔːr k s /) is a trademark for a type of screw drive characterized by a 6-point star-shaped pattern, developed in 1967 [1] by Camcar Textron.

5. Precast concrete lifting anchor system - Wikipedia

   en.wikipedia.org/wiki/Precast_concrete_lifting...

   The anchor selection, together with additional reinforcement, and rigging arrangements is influenced by: - The dead weight of the element - The number of anchors in the element and the configuration of the anchor - Capacity of the anchor at the specific concrete compressive strengths at time of lift - The dynamic loads applied during lifting ...

6. Anchor channel - Wikipedia

   en.wikipedia.org/wiki/Anchor_channel

   Anchor channels, invented by Anders Jordahl in 1913, are steel channels cast flush in reinforced concrete elements to allow the installation of channel bolts for the fastening of components. Anchor channels consist of steel C-shaped channels and anchors (mostly headed studs ) which are connected to the channel by welding or riveting/forging.

7. Screw piles - Wikipedia

   en.wikipedia.org/wiki/Screw_piles

   Large load capacity screw piles may have various components such as flat half helices, Bisalloy cutting tips and helices, cap plates or rebar interfaces for connection to various concrete or steel structures. Most industries use screw piling experts due to the cost efficiencies and, increasingly, the reduced environmental impact.