Search results
Results from the WOW.Com Content Network
At 1 ppm the solution is a very pale yellow. As the concentration increases the colour becomes a more vibrant yellow, then orange, with the final 10,000 ppm a deep red colour. In science and engineering , the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities , e.g. mole fraction or ...
Some express the concentrations as ppmv (parts per million by volume) and some express the concentrations as mg/m 3 (milligrams per cubic meter), while others require adjusting or correcting the concentrations to reference conditions of moisture content, oxygen content or carbon dioxide content.
Atmospheric pollutant concentrations expressed as mass per unit volume of atmospheric air (e.g., mg/m 3, μg/m 3, etc.) at sea level will decrease with increasing altitude because the atmospheric pressure decreases with increasing altitude. The change of atmospheric pressure with altitude can be obtained from this equation: [2]
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
Parts per million (ppm) is usually defined as 1 mg/L CaCO 3 (the definition used below). [20] It is equivalent to mg/L without chemical compound specified, and to American degree . Grain per gallon (gpg) is defined as 1 grain (64.8 mg) of calcium carbonate per U.S. gallon (3.79 litres), or 17.118 ppm.
" indicates that no standard has been identified by editors of this article and ns indicates that no standard exists. μg/L = micrograms per litre, or 0.001 ppm; mg/L = 1 ppm, or 1000 μg/L. * means action level; not a concentration standard.
The fluoride uptake capacity (FUC) of commercial activated alumina can be up to 700 mg/kg. The FUC using V.K. Chhabra's method can be determined as follows: Fluoride solution: Dissolve 22.1 g anhydrous NaF in distilled water and dilute to 1,000 mL. 1 mL = 10 mg fluoride. 10 mL/L = 100 mg/L fluoride.
1.5 g/100 ml log P: 1.35 [2] Vapor pressure ... TWA 100 ppm (410 mg/m 3) [1] REL ... IDLH (Immediate danger) 1000 ppm [1] Safety data sheet (SDS) Methyl methacrylate ...