Ad
related to: expansion joint waterproofing treatment options
Search results
Results from the WOW.Com Content Network
An expansion joint is designed to allow deflection in the axial (compressive), lateral (shear), or angular (bending) deflections. Expansion joints can be non-metallic or metallic (often called bellows type). Non-metallic can be a single ply of rubberized material or a composite made of multiple layers of heat and erosion resistant flexible ...
They are differentiated according to the three basic types of movement: axial, angular and lateral expansion joints. Expansion joints have usage in various sectors, like energy production, paper industry, chemical industry, water treatment, oil and gas. Expansion joints can be used wherever thermal movements or vibration occurs in pipelines.
Another factor is the impact of expansion and contraction on waterproofing systems for decks. Decks constantly move with changes in temperatures, putting stress on the waterproofing systems. One of the leading causes of waterproof deck system failures is the movement of underlying substrates (plywood) that cause too much stress on the membranes ...
A Refractory lined expansion joint is an assembly used in a pipe line to allow it to expand and contract [1] as climate conditions move from hot to cold and helps to ensure that the system remains functional. The refractory-lining can be vibra cast insulation with anchors, abrasion resistant refractory in hex mesh, gunned insulating refractory ...
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
Regardless, sealant-filled joints have been used successfully as a secondary waterproofing measure for standing seam and batten seam roofing applications where low-sloped roofs are less than 250 mm/m (3 inches per foot). Sealants can also be used in joints that are primarily designed to accommodate thermal movement of the copper.
Pin and hanger assembly. A pin and hanger assembly is used to connect two plate girders of a bridge.These assemblies are used to provide an expansion joint in the bridge. One beam (the anchor span) is set on a pier with a short section cantilevered out toward the next pier.
Hempcrete is easier to work with than traditional lime mixes and acts as an insulator and moisture regulator. It lacks the brittleness of concrete and consequently does not need expansion joints. [3] Typically, hempcrete has good thermal and acoustic insulation capabilities, but low mechanical performance, specifically compressive strength. [4]
Ad
related to: expansion joint waterproofing treatment options