Search results
Results from the WOW.Com Content Network
A tri-state type DIP switch can be in one of three positions (+, 0, −) which allows more codes than a binary DIP switch. For example, 8 pole tri-state DIP switches offer 6,561 (3 8) combinations/codes compared to 8 pole binary switches' 256 (2 8) combinations/codes. This makes them especially suitable for encoding devices such as a remote ...
Skinny dual in-line package (SDIP or SPDIP [6]) – Sometimes used to refer to a "narrow" 0.300 in. (or 300 mil) wide DIP, normally when clarification is needed e.g. for DIP with 24 pins or more, which usually come in "wide" 0.600 in wide DIP package. An example of a typical proper full spec for a "narrow" DIP package would be 300 mil body ...
A bonus turn is awarded at 40,000, 50,000, 70,000 or 90,000 points, depending on the dip switch settings. When a full screen (of the four) has been completely filled, "Zip-a-Dee-Doo-Dah" is briefly heard (the same excerpt heard in the middle of the intro of The Wonderful World of Disney in the 70s and 80s). When four full screens are completed ...
DIP packages in this table are 0.3 inches (7.62 mm) row-to-row. SO www means SOIC package with a case width of 'www' in thousandth of an inch . Though some package types are known by more than one name, a common name was chosen to make it easier to compare packages.
Simplified single line diagram of a single-phase transfer switch to select either 'city' (utility) power or local generator power 3-phase Intelligent transfer switch. A transfer switch is an electrical switch that switches a load between two sources. Some transfer switches are manual, in that an operator effects the transfer by throwing a ...
For example, with older PC systems, CPU speed and voltage settings were often made by setting jumpers. Some documentation may refer to setting the jumpers to on, off, closed, or open. When a jumper is on or covering at least two pins it is a closed jumper, when a jumper is off, is covering only one pin, or the pins have no jumper it is an open ...
In 1937 W.B. Schulte, [2] McGall's employer, started the company MICRO SWITCH. The company and the Micro Switch trademark have been owned by Honeywell Sensing and Control since 1950. [3] The name has become a generic trademark for any snap-action switch. Companies other than Honeywell now manufacture miniature snap-action switches.
The switches are measured by how many stages, and how many up/down sorters and crosspoints they have. Switches often have buffers built-in for faster switching. A typical switch may have: A 2×2 and 4×4 down sorter [definition needed] Followed by an 8×8 up sorter [definition needed] Followed by a 2×2 crosspoint banyan switch network