Search results
Results from the WOW.Com Content Network
The TR-6060 contains removable wear pads on the shift forks, and uses aluminum alloys for the main case, extension housing, and clutch housing. It is a double overdrive transmission. The TR-6060 is manufactured by TREMEC (formerly Transmission Technologies Corporation) and is rated for 430 lb⋅ft (580 N⋅m) to 650 lb⋅ft (880 N⋅m) of ...
A motorcycle transmission is a transmission created specifically for motorcycle applications. They may also be found in use on other light vehicles such as motor tricycles and quadbikes , go-karts , offroad buggies, auto rickshaws , mowers, and other utility vehicles, microcars , and even some superlight racing cars.
Harley-Davidson Twin Cam engine at the Harley-Davidson Museum. The Harley-Davidson Twin Cam are motorcycle engines made by Harley-Davidson from 1998 to 2017. Although these engines differed significantly from the Evolution engine, which in turn was derived from the series of single camshaft, overhead valve motors that were first released in 1936, they share a number of characteristics with ...
A new transmission, with the primary drive sealed in an oil bath, was introduced for 1961. [ 4 ] The Topper H was introduced in 1961 (sold through 1965) with a new alloy cylinder head that increased the compression ratio to 8.0:1, a reusable foam air filter, and revisions to the cylinder ports and air intake tube.
The earliest known use of a foot clutch and hand shifter, on motorcycles, was with the first multi-geared transmission on the 1915 Harley Davidson. [10] It is a mechanical linkage that is typically mounted to the left side of the motorbike's fuel tank and is held in place by a slotted piece of metal welded to the frame or the tank. [ 9 ]
Six-speed manual transmissions started to emerge in high-performance vehicles in the early 1990s, such as the 1990 BMW 850i and the 1992 Ferrari 456. The first 6-speed manual transmission was introduced in the 1967 Alfa Romeo 33 Stradale. The first 7-speed manual transmission was introduced in the 2012 Porsche 911 (991). [9]
The mechanism is a little less obvious than that of the other types, but control is fundamentally like that of the Baker system. In this case the controlling factor is the angle between the radius hanger and the transmission yoke; when they are parallel, there is little up-down motion of the transmission yoke and the engine is centered.
The dog leg gearbox is typical of nine- and ten-speed heavy-truck transmissions. In the case of a ten-speed transmission, the gears are 1–5 in the low range and 6–10 in the high range (the 1 position is not used in the high range of a nine-speed transmission).