enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. SCSI connector - Wikipedia

   en.wikipedia.org/wiki/SCSI_connector

   One such in somewhat common use was the VHDCI (Very High Density Cable Interconnect) connector, also known as an "AMP HPCN68M", and sometimes as "SCSI-5". There are 68 pins on the connector in two rows; the pins are 0.8 mm apart. This connector is reputed to suffer fewer bent pins than the 68-pin SCSI-2 connector despite its minuscule pins.

3. Very-high-density cable interconnect - Wikipedia

   en.wikipedia.org/wiki/Very-high-density_cable...

   A VHDCI connector. A very-high-density cable interconnect (VHDCI) is a 68-pin connector that was introduced in the SPI-2 document of SCSI-3. [1] The VHDCI connector is a very small connector that allows placement of four wide SCSI connectors on the back of a single PCI card slot. Physically, it looks like a miniature Centronics type connector ...

4. Parallel SCSI - Wikipedia

   en.wikipedia.org/wiki/Parallel_SCSI

   Diagrams of different Parallel SCSI symbols [1]. Parallel SCSI is not a single standard, but a suite of closely related standards. There are a dozen SCSI interface names, most with ambiguous wording (like Fast SCSI, Fast Wide SCSI, Ultra SCSI, and Ultra Wide SCSI); three SCSI standards, each of which has a collection of modular, optional features; several different connector types; and three ...

5. Ribbon cable - Wikipedia

   en.wikipedia.org/wiki/Ribbon_cable

   Left: 20-way grey ribbon cable with wire for pin 1 marked red, insulation partly stripped. Right: 16-way rainbow ribbon with IDC connector. IDC D-sub connectors DE-9 (male) and DA-15 (female) Twisted ribbon cable used for Parallel SCSI connections. A ribbon cable is a cable with many conducting wires running parallel to each other on the same ...

6. SCSI - Wikipedia

   en.wikipedia.org/wiki/SCSI

   Internal parallel SCSI cables are usually ribbons, with two or more 50–, 68–, or 80–pin connectors attached. External cables are typically shielded (but may not be), with 50– or 68–pin connectors at each end, depending upon the specific SCSI bus width supported.

7. Serial Attached SCSI - Wikipedia

   en.wikipedia.org/wiki/Serial_attached_SCSI

   The most common connection [33] for SAS drives connecting to backplanes in servers, i.e. PowerEdge [34] and ProLiant [35] SFF-8484 [36] [37] internal 32 or 19 4 or 2 High-density internal connector, 2 and 4 lane versions are defined by the SFF standard. SFF-8485 [38] Defines SGPIO (extension of SFF 8484), a serial link protocol used usually for ...