enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Camshaft - Wikipedia

   en.wikipedia.org/wiki/Camshaft

   The lobe separation angle (LSA, also called lobe centreline angle) is the angle between the centreline of the intake lobes and the centreline of the exhaust lobes. [23] A higher LSA reduces overlap, which improves idle quality and intake vacuum, [22] however using a wider LSA to compensate for excessive duration can reduce power and torque ...

3. Cam (mechanism) - Wikipedia

   en.wikipedia.org/wiki/Cam_(mechanism)

   The cam can be seen as a device that converts rotational motion to reciprocating (or sometimes oscillating) motion. [clarification needed] [3] A common example is the camshaft of an automobile, which takes the rotary motion of the engine and converts it into the reciprocating motion necessary to operate the intake and exhaust valves of the cylinders.

4. Hydraulic tappet - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_tappet

   Oil under constant pressure is supplied to the lifter via an oil channel, through a small hole in the lifter body. When the engine valve is closed (lifter in a neutral position), the lifter is free to fill with oil. As the camshaft lobe enters the lift phase of its travel, it compresses the lifter piston, and a valve shuts the oil inlet.

5. Variable camshaft timing - Wikipedia

   en.wikipedia.org/wiki/Variable_camshaft_timing

   For twin-cam or DOHC engines, VCT was used on either the intake or exhaust camshaft. (Engines that have VCT on both camshafts are now designated as Ti-VCT.↓) The use of variable camshaft timing on the exhaust camshaft is for improved emissions, and vehicles with VCT on the exhaust camshaft do not require exhaust gas recirculation (EGR) as retarding the exhaust cam timing achieves the same ...

6. Rocker arm - Wikipedia

   en.wikipedia.org/wiki/Rocker_arm

   Some OHC engines employ short rocker arms, also known as fingers, in which the cam lobe pushes down (rather than up) on the rocker arm to open the valve. On this type of rocker arm, the fulcrum is at the end rather than the middle, while the cam acts on the middle of the arm. The opposite end opens the valve.

7. Variable valve timing - Wikipedia

   en.wikipedia.org/wiki/Variable_valve_timing

   One end of the cam lobe has a short duration/reduced lift profile, and the other end has a longer duration/greater lift profile. In between, the lobe provides a smooth transition between these two profiles. By shifting area of the cam lobe which is in contact with the follower, the lift and duration can be continuously altered.

8. Helical camshaft - Wikipedia

   en.wikipedia.org/wiki/Helical_camshaft

   The mechanism is a coaxial shaft arrangement where the outer shaft carries the main body of the cam lobe. The main body of the cam lobe is in its maximum duration form. Typically the main lobe body would have a duration of about 450°. The lobe is very long axially, about 45 mm (1.8 in), and its profile consists of conventional opening and ...

9. Tappet - Wikipedia

   en.wikipedia.org/wiki/Tappet

   In an overhead valve engine the tappets (on right) are sandwiched between pushrods and the camshaft. In an internal combustion engine, a tappet (also called a 'valve lifter' or 'cam follower') [3] [4] [5] is the component which converts the rotation of the camshaft into vertical motion to open and close an intake or exhaust valve.