enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Useful conversions and formulas for air dispersion modeling

    en.wikipedia.org/wiki/Useful_conversions_and...

    Atmospheric pollutant concentrations expressed as mass per unit volume of atmospheric air (e.g., mg/m 3, μg/m 3, etc.) at sea level will decrease with increasing altitude because the atmospheric pressure decreases with increasing altitude. The change of atmospheric pressure with altitude can be obtained from this equation: [2]

  3. Air pollutant concentrations - Wikipedia

    en.wikipedia.org/wiki/Air_pollutant_concentrations

    mg/m 3 = milligrams of pollutant per cubic meter of air at sea level atmospheric pressure and T: ppmv = air pollutant concentration, in parts per million by volume T = ambient temperature in K = 273. + °C 0.082057338 = Universal gas constant in L atm mol −1 K −1: M = molecular mass (or molecular weight) of the air pollutant

  4. Orders of magnitude (mass) - Wikipedia

    en.wikipedia.org/wiki/Orders_of_magnitude_(mass)

    However, the names of all SI mass units are based on gram, rather than on kilogram; thus 10 3 kg is a megagram (10 6 g), not a *kilokilogram. The tonne (t) is an SI-compatible unit of mass equal to a megagram (Mg), or 10 3 kg. The unit is in common use for masses above about 10 3 kg and is often used with SI prefixes.

  5. Metric system - Wikipedia

    en.wikipedia.org/wiki/Metric_system

    Since all gases have the same volume per mole at a given temperature and pressure far from their points of liquefaction and solidification (see Perfect gas), and air is about ⁠ 1 / 5 ⁠ oxygen (molecular mass 32) and ⁠ 4 / 5 ⁠ nitrogen (molecular mass 28), the density of any near-perfect gas relative to air can be obtained to a good ...

  6. Air permeability specific surface - Wikipedia

    en.wikipedia.org/wiki/Air_permeability_specific...

    δP is the pressure drop across the bed, Pa l is the cylinder length, m η is the air dynamic viscosity, Pa·s Q is the flowrate, m 3 ·s −1. It can be seen that the specific surface is proportional to the square root of the ratio of pressure to flow. Various standard methods have been proposed: Maintain a constant flowrate, and measure the ...

  7. Pressure measurement - Wikipedia

    en.wikipedia.org/wiki/Pressure_measurement

    Using atmospheric pressure as reference is usually signified by a "g" for gauge after the pressure unit, e.g. 70 psig, which means that the pressure measured is the total pressure minus atmospheric pressure. There are two types of gauge reference pressure: vented gauge (vg) and sealed gauge (sg).

  8. Jerky seller allegedly threatens Capital One execs with ... - AOL

    www.aol.com/jerky-seller-threatens-attack...

    A Texas jerky seller allegedly threatened to show up to a Capital One office with “a machete and gasoline” and “do things that are unforgivable” in a rage at a $543 debt, according to a ...

  9. Equivalent weight - Wikipedia

    en.wikipedia.org/wiki/Equivalent_weight

    The equivalent weights of the three acids 63.04 g, 204.23 g and 389.92 g respectively, and the masses required for the standardisation are 126.1 mg, 408.5 mg and 779.8 mg respectively. Given that the measurement uncertainty in the mass measured on a standard analytical balance is ±0.1 mg, the relative uncertainty in the mass of oxalic acid ...