Search results
Results from the WOW.Com Content Network
Obduction zones occurs when the continental plate is pushed under the oceanic plate, but this is unusual as the relative densities of the tectonic plates favours subduction of the oceanic plate. This causes the oceanic plate to buckle and usually results in a new mid-ocean ridge forming and turning the obduction into subduction. [citation needed]
A transform fault or transform boundary, is a fault along a plate boundary where the motion is predominantly horizontal. [1] It ends abruptly where it connects to another plate boundary, either another transform, a spreading ridge, or a subduction zone. [2] A transform fault is a special case of a strike-slip fault that also forms a plate boundary.
Strike-slip tectonics or wrench tectonics is a type of tectonics that is dominated by lateral (horizontal) movements within the Earth's crust (and lithosphere).Where a zone of strike-slip tectonics forms the boundary between two tectonic plates, this is known as a transform or conservative plate boundary.
Where the plates meet, their relative motion determines the type of plate boundary (or fault): convergent, divergent, or transform. The relative movement of the plates typically ranges from zero to 10 cm annually. [5] Faults tend to be geologically active, experiencing earthquakes, volcanic activity, mountain-building, and oceanic trench formation.
Mid-ocean ridge – Basaltic underwater mountain system formed by plate tectonic spreading; Pit crater – Depression formed by a sinking or collapse of the surface lying above a void or empty chamber; Pyroclastic shield – Shield volcano formed mostly of pyroclastic and highly explosive eruptions; Resurgent dome – Volcanic landform
A special class of strike-slip fault is the transform fault when it forms a plate boundary. This class is related to an offset in a spreading center, such as a mid-ocean ridge, or, less common, within continental lithosphere, such as the Dead Sea Transform in the Middle East or the Alpine Fault in New Zealand. Transform faults are also referred ...
Indo-Australian plate – Major tectonic plate formed by the fusion of the Indian and Australian plates (sometimes considered to be two separate tectonic plates) – 58,900,000 km 2 (22,700,000 sq mi) Australian plate – Major tectonic plate separated from Indo-Australian plate about 3 million years ago – 47,000,000 km 2 (18,000,000 sq mi)
Extensional tectonics is associated with the stretching and thinning of the crust or the lithosphere.This type of tectonics is found at divergent plate boundaries, in continental rifts, during and after a period of continental collision caused by the lateral spreading of the thickened crust formed, at releasing bends in strike-slip faults, in back-arc basins, and on the continental end of ...