Search results
Results from the WOW.Com Content Network
Connectors usually used for computer fans are the following: Three-pin Molex connector KK family This Molex connector is used when connecting a fan to the motherboard or other circuit board. It is a small, thick, rectangular in-line female connector with two polarizing tabs on the outer-most edge of one long side.
Full-tower computer cases may contain multiple cooling fans. At the top of the case is a fan controller. Fan control is the management of the rotational speed of an electric fan. In computers, various types of computer fans are used to provide adequate cooling, and different fan control mechanisms balance their cooling capacities and noise they ...
Another common method for internal case modding uses the power outlet for the internal fan by splitting the cord with a "Y" connector. However, the most up to date modders will use power points under where the PSU (power supply) plugs in, which doesn't diminish any (or very little) power from the console.
An opened ATX case, front towards right. Components pictured include a microATX motherboard (top), a CPU (beneath the Cooler Master fan), a GPU (middle), and an SSD (right). The power supply is housed in the compartment at bottom. A computer case, also known as a computer chassis, is the enclosure that contains most of the hardware of a ...
Fans may be fitted to the computer case or attached to CPUs, GPUs, chipsets, power supply units (PSUs), hard drives, or as cards plugged into an expansion slot. Common fan sizes include 40, 60, 80, 92, 120, and 140 mm. 200, 230, 250 and 300 mm fans are sometimes used in high-performance personal computers.
Some computer fans, especially smaller ones (80mm or less) use a 2-pin connector, which is present on graphics cards. It is somehow similar to the 3-pin Molex connector used for fans, but it is not just a 3-pin Molex with one pin less. You cannot plug these connectors into 3-pin Molex headers. Many of these fans can be found here e.g. and .
Abram had the same tree for Kurt last year, and the cat seems to remember it; it's clear he's a fan. Watch until the end to see Kurt try to get from one tree to another - it's the cutest thing ever!
A regular computer case may require/include [5] 7 thumb screw 6-32 × 6 mm for 2.5” drive tray, expansion slots; 4 hexagon screw 6-32 × 6 mm for psu; 21 phillips screw 6-32 × 5 mm for motherboard, 3.5” harddisk tray; 12 phillips screw M3 × 5 mm for 2.5” harddrive; 16 KB5 x 10 mm for fans; 9 standoff 6-32 × 6.5 + 4 mm for motherboard