enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Micrometer (device) - Wikipedia

   en.wikipedia.org/wiki/Micrometer_(device)

   Modern micrometer with a reading of 1.639 ± 0.005 mm. Assuming no zero error, this is also the measurement. (One may need to enlarge the image to read it.) Outside, inside, and depth micrometers. The outside micrometer has a unit conversion chart between fractional and decimal inch measurements etched onto the frame

3. Gauge (instrument) - Wikipedia

   en.wikipedia.org/wiki/Gauge_(instrument)

   Hole gauge [3] used to gage internal dimensions of bores that are either too small in diameter for an inside micrometer, and have greater economy than a bore gage or other precision internal gage. Caliper: a device used to measure the distance between two opposing sides of an object. Center gauges and fishtail gauges

4. Mitutoyo - Wikipedia

   en.wikipedia.org/wiki/Mitutoyo

   Mitutoyo America Corporation was formed in 1963 and is headquartered in Aurora, Illinois (just outside Chicago).Mitutoyo America offers the full product line of precision measuring tools, instruments and equipment with a distribution network, training and education classes, software development, and service support to provide a comprehensive metrology organization.

5. Calipers - Wikipedia

   en.wikipedia.org/wiki/Calipers

   Two inside calipers. Inside calipers are used to measure the internal size of an object. The upper caliper in the image (on the right) requires manual adjustment prior to fitting. Fine setting of this caliper type is performed by tapping the caliper legs lightly on a handy surface until they will almost pass over the object.

6. Gauge block - Wikipedia

   en.wikipedia.org/wiki/Gauge_block

   A small number of gauge blocks can be used to create accurate lengths within a wide range. By using three blocks at a time taken from a set of 30 blocks, one may create any of the 1000 lengths from 3.000 to 3.999 mm in 0.001 mm steps (or .3000 to .3999 inches in 0.0001 inch steps).

7. Snap gauge - Wikipedia

   en.wikipedia.org/wiki/Snap_gauge

   Snap go/no go gauge and indicator snap gauge. A snap gauge is a form of go/no go gauge.It is a limit gauge with permanently or temporarily fixed measurement aperture(s) (gaps) which is used to quickly verify whether an outside dimension of a part matches a preset dimension or falls within predefined tolerances.