Search results
Results from the WOW.Com Content Network
Concrete chipping is a process which requires trained chippers or a robotically-controlled machine with an ultra high pressure water source (20,000 psi) to enter the drums of ready-mix concrete trucks and central mixers to break away the dried concrete along the drums’ walls.
In modern construction, scabbling is a mechanical process of removing a thin layer of concrete from a structure, typically achieved by compressed air powered machines. A typical scabbling machine uses several heads, each with several carbide or steel tips that peck at the concrete. It operates by pounding a number of tipped rods down onto the ...
A fairly well-defined reaction front can often be observed in thin sections; ahead of the front the concrete is normal, or near normal. Behind the reaction front, the composition and the microstructure of concrete are modified. These changes may vary in type or severity but commonly include: Extensive cracking; Expansion
Concrete may be considered waste according to the European Commission decision of 2014/955/EU for the List of Waste under the codes: 17 (construction and demolition wastes, including excavated soil from contaminated sites) 01 (concrete, bricks, tiles and ceramics), 01 (concrete), and 17.01.06* (mixtures of, separate fractions of concrete ...
construction site workers loading water, sand, ballast and cement into a concrete mixer. Concrete is typically used in commercial buildings and civil engineering projects, for its strength and durability. Concrete is a mix of cement and water plus an aggregate such as sand or stone. Its compression strength means it can support heavy weights. [5]
Shotcrete, gunite (/ ˈ ɡ ʌ n aɪ t /), or sprayed concrete is concrete or mortar conveyed through a hose and pneumatically projected at high velocity onto a surface. This construction technique was invented by Carl Akeley and first used in 1907. [1]: 7 The concrete is typically reinforced by conventional steel rods, steel mesh, or fibers.
The wearing course, also known as a friction course or surface course, is the upper layer in roadway, airfield, and dockyard construction. The term 'surface course' is sometimes used slightly different, to describe very thin surface layers such as chip seal. In rigid pavements the upper layer is a portland cement concrete slab.
Examples of these include: elevators, structural steel, trusses, pre-cast concrete, windows, appliances, cabinets, air handling units, and millwork. Also critical are the installation and coordination shop drawings of the MEP trades such as sheet metal ductwork, piping, plumbing, fire protection, and electrical.