Search results
Results from the WOW.Com Content Network
Meaning, air density is the generally the same for flat-fire trajectories, thus sectional density is equal to the ballistic coefficient and air density can be dropped. Then as the velocity rises to Bashforth's k {\displaystyle k} for high velocity when C {\displaystyle C} requires the introduction of i {\displaystyle i} .
Projectiles are described by a ballistic coefficient, or BC, which combines the air resistance of the bullet shape (the drag coefficient) and its sectional density (a function of mass and bullet diameter). The deceleration due to drag that a projectile with mass m, velocity v, and diameter d will experience is proportional to 1/BC, 1/m, v² and ...
The FMJ cartridge has a Copper-Zinc alloy case and uses a double base propellant. The bullet is a 4.1 g (63 gr) tombac jacketed FMJ projectile with a G1 ballistic coefficient of 0.331 (ICAO) / 0.337 (Army Metro). The projectile contains approximately 95% Pb, 2% Sb, 3% Cu, and was designed for terminal ballistic instability.
They used heavier and more aerodynamic bullets that had a higher ballistic coefficient than standard ball rounds, meaning they shed velocity at longer ranges more gradually. [11] Maintaining velocity is important for accurate long-range shots because dropping from supersonic to transonic speeds disturbs the flight of the bullet and adversely ...
Within external ballistics, when the sectional density of a projectile is divided by its coefficient of form (form factor in commercial small arms jargon [3]); it yields the projectile's ballistic coefficient. [4] Sectional density has the same (implied) units as the ballistic coefficient.
Most VLD bullets are used in rifles. VLD bullets typically have a ballistic coefficient greater than 0.5, although the threshold is undefined. [1] Bullets with a lower drag coefficient decelerate less rapidly. A low drag coefficient flattens the projectile's trajectory and also markedly decreases the lateral drift caused by crosswinds. The ...
A ballistic tip bullet is a hollow-point rifle bullet that has a plastic tip on the end of the bullet. This improves external ballistics by streamlining the bullet, allowing it to cut through the air more easily, and improves terminal ballistics by allowing the bullet to act as a jacketed hollow point.
The US Army's Ballistic Research Laboratory measured a ballistic coefficient (G7 BC) of 0.168 and form factor (G7 i) of 0.929 for the 7N6(M) projectile, which indicates good aerodynamic efficiency and external ballistic performance for the bullet diameter. [24] [25] The rounds are loaded to produce a maximal pressure of 290.00 MPa (42,061 psi ...