Search results
Results from the WOW.Com Content Network
Both pre and post Doppler methods can be used in the beamspace. Post Doppler methods may also be used on the full antenna element input as well to reduce the data in this dimension only. A popular example is displaced phase center antenna (DPCA), which is a form of data-independent STAP in the beamspace, pre-Doppler. [7]
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Pages for logged out editors learn more
All of the typical measurements that a non-monopulse system make are done using the sum channel, e.g., range, Doppler, and angle. However, the angle measurement is limited in that the target could be anywhere within the beam width of the sum beam, and therefore the system can only assume that the beam pointing direction is the same as the ...
In the cross-range coordinate, the similar resolution is mainly proportional to the bandwidth of the Doppler shift of the signal returns within the beamwidth. Since Doppler frequency depends on the angle of the scattering point's direction from the broadside direction, the Doppler bandwidth available within the beamwidth is the same at all ranges.
In pulsed radar and sonar signal processing, an ambiguity function is a two-dimensional function of propagation delay and Doppler frequency, (,).It represents the distortion of a returned pulse due to the receiver matched filter [1] (commonly, but not exclusively, used in pulse compression radar) of the return from a moving target.
Moving target indication (MTI) is a mode of operation of a radar to discriminate a target against the clutter. [1] It describes a variety of techniques used for finding moving objects, like an aircraft, and filter out unmoving ones, like hills or trees.
Pulse-Doppler signal processing is a radar and CEUS performance enhancement strategy that allows small high-speed objects to be detected in close proximity to large slow moving objects. Detection improvements on the order of 1,000,000:1 are common.
The chirp pulse compression process transforms a long duration frequency-coded pulse into a narrow pulse of greatly increased amplitude. It is a technique used in radar and sonar systems because it is a method whereby a narrow pulse with high peak power can be derived from a long duration pulse with low peak power.